Your cart is empty.
Your cart is empty. 20 Pack Cable Chase Wire Bracket for Tight Install NMB Electrical Cable Cord Wire,Time&Labor Saving
Hole Size: 1”
Main Body: 2 1/2 “x 6 3/8”
Cable Chase Plate: 1 1/8“ x 6 3/8”
1-inch 10-hole design is suitable for most elcetrical wires/cord/cables to meet your needs (Especially for NMB wire).
Mantain wires tidy:
This wire cord cable management are flexible enough to allow for future expansion of space, and the use of electrical wire chase bracket make cable routing more organized for ease of maintenance and access, providing an effective way to organize cabling along walls, under ceilings, or in tight spaces.
Fast and tight installation:
Cable cord support bracket wire holder bracket are easy to install, and the design allows multiple cables to be easily routed in limited spaces, making the installation process smooth and efficient and human resources run faster and greatly saving time and effort.
Reduce damage:
Reduce potential damage from vibration or friction by securing cables and preventing them from sagging or moving.
Cable chase bracket wire support cable stackers prevent unnecessary drilling into house joists, wood, or ceilings, reducing the chance of structural damage, and the smooth surface keeps the wire safe and away from sharp wood chip edges.
NEWoods
2025-08-14 16:32:02
I needed to run a wire across some rafters in the attic and this made running them a lot easier, and gave me options in the future to run more. Got these this week and decided to try them out, glad I waited for them rather than stapling the cable. went faster so I didn't have to spend as much time up there.Easily able to get 2 to 3 12/2 cables through each hole. The plastic seems to be extremely durable and didn't bend much at all when I tried to break one. Holes for mounting to the frame are setup that gives you a couple of options.Might start using these to run cables in crawl spaces of businesses, I usually have to run cat cable around attics and crawl spaces and instead of drilling joists or putting staples in this gives me options to expand in the future. And the cost might be prohibitive if you need them for your house, but for a business they would make mounting cable much faster and more versatile.
Product works as advertised
2025-07-20 18:26:25
Just as advertised
Philip J
2025-06-02 09:13:17
Perfect construction. I assumed it was metal, but plastic works better at preserving cable insulation. The alignment of the holes is spot on so the straight pulls are easy. The play is angled off of the vertical and I don't know why, but with all the other thoughtful design considerations, in sure it is a good idea.
Joe W.
2025-05-18 17:00:43
When I bought these, the listing said they were steel, which is what I wanted. They are plastic. Two stars because they look like they should do the job if plastic is OK with you.
JB
2025-05-02 11:21:21
Ordered this 12Pack Cable Chase Wire Bracket,Cable Chase Bracket Support Organizer for NMB,Wire Stackers Keep Electrical Cord Tidy Clean&Save Time Space Labor,1" with 10-Hole Design for use with ethernet coax and other low voltage cables entering a wiring cabinet. For that purpose it is suitable, organizing cables existing a wall that are not line voltage. Unfortunately the listing says they are good for line voltage NM cable and I do not think they are at all optimal for that purpose and likely will be rejected by an inspector because they do not secure the cables.The reason for the two star review is because I am an electrician and can say for sure that in my jurisdiction that this is not suitable means of securing line voltage cable. The NEC requires that wires be secured and supported every 6 feet, I don't see any UL listing or reason to believe these will work as the listing images indicate. The cable is not secured, if you were to run these lets say below rafters in a open ceiling the lines would sag. There are clips that are listed and made specifically to secure NM cables, they nail in easily and are compact clipping each wire in place and can be ran inside walls. The way these work they stick out really far and are again not suitable for use inside walls based on the way they attach. So if you are buying these for NM cables as the listing states I would strongly recommend buying another product. I did quick forum research and see posts from people confirming electrical inspectors required this style bracket to be removed from line voltage installations.Now for the purpose I ordered them, organizing HDMI, ethernet and audio cables entering a wiring cabinet they may have some value. Even then though I am not sure they are superior to a zip tie. They are larger than I expected and just bulky. I was hoping for a UL listing on them but did not do my research before ordering.
Jay
2025-04-19 13:16:14
Decent quality plastic mold injected pieces.Check locally to see if they are legal in your area for electrical inspectionHowever using these to organized other wires such as low voltage ethernet or other wires is most likely fine.
AZsinceforever
2025-03-29 18:17:47
Know that this is not a code-approved way to manage AC cables, but it could be used for low voltage cabling. As it happens though, it works great for 1/2" PEX lines: I have multiples running through some joist bays and this was perfect to corral them along the span.These are very rigid plastic and do not feel brittle, which is good.
Gabriel
2024-12-27 09:26:51
Soft rounded edges, didn't find a ul listing stamp but pretty good for keeping wire runs organized and grouped together.
Recommended Products
