Your cart is empty.
Your cart is empty. A standard wall charger usually requires 4~5 hours of monitoring & you will never really know if a pack is fully charged or over-charged. This smart charger will peak the charge, stop charging when full, & provides a green/red led light so you never have to do any guess work.
Instructions:
Connect pack to output connector & plug AC power source
Make sure polarity is connected correctly (Red wire is positive)
Charger will detect voltage, Red LED will be on during charging
When fully charged, current will reduce to trickle at 50mA, Green LED will be on
Will be charging at 0.9A or 1.8A constant current
Approx charging time is ~1.5hrs for 3000mAh, ~1hr for 1800mAh
The charger is designed for faster charging NiCd & NiMH packs from 6 to 12V
Caution:
Don't charge packs w/ voltage less than 6V or voltage greater than 12V & capacity smaller than 1100mAh
Pack MUST be made by high drain current cell
Charger is for NiCd / NiMh type packs; NOT for Li-Polymer, Li-Mn, Li-Ion type packs (Using w/ a lipo will cause fire or serious injury)
Charger is designed for indoor use only. Don't leave charger unattended during charging
Charger should be set horizontally & in well ventilated condition, avoid water & keep away from flammable / explosive goods
Don't cover the charger when charging; ambient temperature shall not be more than 40C
Don't leave batteries charging on flammable surfaces, wood, or carpet
Cut off the power supply before connecting or disconnecting charger from batteries
Don't try to disassemble charger (High voltage inside)
Mfg is not responsible for any damage & consequent damage caused by misuse
Certifications: EMC, LVD, FCC, CE, RoHs
Includes: Charger, Small Tam Female, Large Male Tam to Small Female Adapter, Small Female Tam to DEANS Adapter
Compatibility: For 6v-12v Ni-Mh / Ni-Cd Battery Pack
Input: AC110 - 240V
Output: 6-12V .9A or 1.8A
