Your cart is empty.
Your cart is empty. Specification:
Item Type: Vector Frequency Converter
Material: ABS
Storage Temperature: -25?-55?
Input Voltage: 3 phase 340V-440V AC 50-60Hz
Output Voltage: 3 phase 0-440V AC 0-400Hz
Output Current: 12.6A
Braking Resistor Selection:
Braking Resistor Power: 800W
Braking Resistor Value: 100?
How to Use:
1. Before wiring, please make sure that the input power is in the power off state.
2. For wiring operation, please ask professional electrical engineering personnel to do it.
3. Grounding terminal, please make sure to ground.
4. After wiring the emergency stop circuit, make sure to check whether the action is effective.
5. The output line of the inverter must not be connected to the shell, and the output line must not be short circuited.
6. Please make sure the voltage of the AC main circuit power supply is the same as the rated voltage of the inverter.
7. Please do not perform voltage withstand test on the inverter.
8. Please connect the braking resistor according to the wiring diagram.
9. Do not connect the power cable to the output U, V, W terminals.
10. Do not connect the contactor to the output circuit.
11. Be sure to install the protective cover before power is applied. When removing the cover, be sure to disconnect the power supply.
12. Do not use the inverter with the reset and retry function near the equipment. Because it will start again suddenly when the alarm stops.
13. Make sure that the alarm is reset only after the is cut off. If the alarm is reset under the running , the inverter may start suddenly.
14. Do not touch the terminals of the inverter, there is high voltage on the terminals, which is very dangerous.
15. Do not change the wiring or disassemble the terminals while the power is on.
Package List:
1 x Vector Frequency Converter
1 x Instruction
Note:
1. Cut off
