Your cart is empty.
Your cart is empty.Product Description
Packaging includes
1 - Manifold heat shield
1 - Fuel rail heat cover
6 - Fuel injector covers
12 - OE replacement fuel injector O-rings
- (As shown in the picture)
010378 Fuel Rail and Injector Cover Kit
Compatible models
1997-2004 4.0L JEEP Models with Inline 6 Motor
1997-2004 Jeep Grand Cherokee
1997-2004 Jeep TJ
1997-2004 Jeep Wrangler
1997-2001 Jeep Cherokee
- Effective solution to the common problem of heat soak & vapor lock in Jeep models
- Reduces fuel rail & injector fuel temps
- Reduces chance of vapor lock
- Protects injectors & fuel rail from engine heat
Why Choose GEATaaT?
JJ
2025-06-01 15:16:21
The manifold shield is thick and sturdy. Does require removal of fuel rail for proper installation. Coverage for the manifold is better than the flimsy OEM cover! You will need to make slots for mounting tabs on the fuel rail and may have to adjust the injector holes. The injector covers slip right on and will require the injectors to be removed (easier to slip on with velcro closed).Overall this kit took a little over an hour to install with a 10mm socket and open end wrench. You'll need to have the proper tool to remove the fuel supply line from the injector rail and is a good time to cover the fuel line down to the firewall as well. Really good value!
GARRETT R.
2025-05-28 15:40:33
Kit fit up well in my 02 tj. I had to trim the hard guard to clear 2 spots see photos. The fuel rail piece was almost perfect but I did add some ss zip toes for extra caution. I was nervous about thr o rings for injectors but so far so good no leaks. My issue was hot starts on hot days. I'd park and if I didn't give it time to cool I couldn't get it to start unless I burped the pressure off the fuel rail. The new gas would be liquid and would start back up. This has solved that and at a good price. I would rec9mmend but they make this to fit alot of models so you'll have to do some fine tuning
Michael
2025-05-20 16:43:08
Actually better than I expected.
Al Pizzica
2025-05-10 19:39:11
As advertised, holding up well.
Steve
2025-04-09 14:42:27
I picked this up for my 2001 XJ with the 4.0L inline six engine. The original heat shield was in terrible shape, so I pulled it out, but got heat soak a couple of times during the hotter part of the summer. You have to pull the fuel rail and injectors to install the kit, it is not that hard of a project but you do want to make sure that you have the fuel disconnect tool before you dive into it. The heat shield fits well, but is thinner and stiffer than the original one was. The fuel-rail wrap needed slight modification to fit around the pressure regulator and mounting flanges, but once that was done it fit well. The kit includes new O-rings to put on the injectors. I’m rating the kit at 4-stars because the fuel-rail wrap needed a bit of modification, but it really wasn’t that hard.
Willjam
2025-02-24 17:43:33
I still rate it five stars as its doing what it says it would do. Mitigated the heat problem under my hood.... just wear gloces when installing... this product looks innocent enough but has potential to be a survival weapon if need be. SHARP EDGES - BE CAREFUL~~!
Customer
2024-12-28 18:41:21
Did not fit vehicle as advertised.
Customer
2024-11-19 14:11:07
loose fiberglass strands everywhere,bad stitching, pulling out strings
Recommended Products