Your cart is empty.
Your cart is empty.Bill
2025-06-13 20:31:53
The spacer fit perfectly on my Holly double pumper carb and modified the air cleaner hight just right. Great buy!
Taryn and Jake
2025-06-12 13:53:08
Perfect for holly 850 double pumper. Choke clears now without any issue. Raised air filter just enough to clear linkage but not hit the hood
Sandra McNeely
2025-05-29 18:45:03
Bought this to get my air cleaner above the top of an hei distributor. You will need to have some under hood clearance to use this. I have an 81 CJ 5 with a sbc. I am using the eps manifold with a holley carb. The air cleaner would hit the distributor before I installed the spacer. I suppose you could trim it if you wanted. It is made of plastic.
Darrell
2025-04-25 10:07:25
It's a fine spacer, dimensionally fits the air cleaner and the carb, but it doesn't allow the air cleaner to just sit on it in alignment with the carb. I have to hold it down when tightening the nut on the cleaner to ensure that it stays in line. Otherwise good product.
Gary Kachur
2025-03-08 19:35:45
I remover the spacer under my Edelbrock carburator and needed this spacer to keep my air cleaner at the right height. Works great, fit perfect.
Scott Taylor
2025-03-02 15:28:56
If you need more clearance for choke or throttle linkage, or you want to move the breather up closer to the hood for a scoop, this is a cheap and easy way to do it. Perfect fit for a standard 4bbl setup.
KingKoolDaddy
2025-02-23 14:13:39
You get what you pay for, should have bought name brand. This is a cheap, plastic 2" spacer, and the breather 'teeters' atop it. Tighten your breather nut just too much and it'll slip to the side. I made it work, but barely. I don't recommend
Danny New
2025-02-03 11:12:10
Used the 1/2" spacer to keep my factory GM breather after installing the edelbrock 1406. Use on my 350 and 327 engines both.
Recommended Products
$42.00
$ 18 .99 $18.99
$38.95
$ 16 .99 $16.99
$49.95
$ 21 .99 $21.99