Your cart is empty.
Your cart is empty. Specifications:
Working voltage: 7-24V(24V is the limit voltage, which can be powered by a switching power supply, but cannot be connected to a 24V battery, because the full voltage of the 24V battery is close to 29V)
Drive current: Rated 12A (if add fan for Cold 20A)
Maximum Speed: 224000 RPM (2-pole motor), 74000 RPM (6-pole motor), 40000 RPM (12-pole motor), 35000RPM (14-pole motor)
please connect the wire correctly to avoid damage:UVW phase line output is connected to the motor, VCC/GND main power supply (external DC power supply)
Note:
There is no fuse on the power supply circuit on the main board, it is recommended to add it yourself, do not reverse the positive and negative poles of the power supply;
Please do not artificially short circuit when the module is not working normally, otherwise it may burn the line and burst the tube. Please test with a low current and low voltage for the first wiring test machine. After OK, then pass a large current and a large voltage;
Please do not connect the motor that obviously does not match the voltage, current and power of the drive module.
We highly appreciate all customers opinions to improve the selling, also if anything you unsatisfied, please contact us for probable best solution.
Package Includes: 1pcs
Naomi (Alt) Zwelling
2025-06-18 12:08:27
the one I got had a button instead of potentiometer and was low speed and half the time didnt work
Mariana M.
2025-06-02 14:31:44
The controller operates smoothly, though as stated in the product description it gets very hot. So far I've used this for a few months and had no issues with it.
R F
2025-04-25 16:40:25
I bought this to control a BLDC motor designed for drone airplanes to operate in a blower. Testing it at 9-11V (well within motor spec) from a bench supply able to supply up to 6A, it started behaving eratically above 1.5A, suddenly tripping overcurent protection in the power supply and then rapidly switching between braking and accelerating the motor a few times before entering a shutdown mode. This was with the pot very low.Trying a beefier PSU, the ESC just immediately burned itself out and no longer operates.
A. Pinkley
2025-04-17 15:44:52
I made the mistake of removing the extension wires from this device and soldering my plug directly to this device before testing. The motor would barely turn them it would fail. The heat sink is just an aluminum plate and there is not sufficient thermal tape to cover all of the amplifiers.I have another one that was a different listed item from Amazon and it is still running great. It has a finned heat sink - not all are constructed the same.
Ethan
2025-04-07 15:21:25
Bought this to test an electric motor I hand built with 3d printed parts. I didn't have much expectations, but to my surprise the ESC worked perfectly and the motor spun to life at an alarming speed. Very handy.
chris
2025-02-26 13:03:58
The second I connected to a 12v power source it went up in smoke
chris
2025-02-25 11:22:26
Works as intended with 24v or less. I over volted to try to spin a larger motor and it did work for a few moments. Just trying to prove the wiring and motor were sound. Stay with in parameters and it is flawless.
Dmitry Romanovich
2024-12-03 15:38:56
The media could not be loaded.
Recommended Products
