Your cart is empty.
Your cart is empty. Material: plastic and metal
Shape: Round
Resistance: 10K ohm
Resistance tolerance: + 5%
Independent linear accuracy: 0.25%
Power: 2W
Operating temperature range: +1°C+125°C
Storage temperature: -55°C - +125°C
Rotating life: 1000000
Load life: 1000 hours
Angle of Rotation : 3600±5°
Shaft diameter: 6.35mm/0.25in
Jeff W
2025-08-23 10:23:23
This has only been in use for a few months, but linearity and build quality seem very good.Only downside - the pot itself turns smoothly, the supplied knob is stiff.
texasconnie
2025-06-15 12:53:49
This is a brand name bourns
Jeff
2025-05-29 14:03:10
This potentiometer has the worst response ever. Small movements spike all sorts of resistances, it jumps all over the place. Certainly not something you want with a multi-turn pot. Additionally, if you put the count/position knob on you basically can't turn it without excessive force. Do not buy.
Chaomin Guan
2025-05-06 11:59:38
No.2 contact is the one protruding the bottom cap, as long as we figure this out, getting the resistance we need is no brainer then. I needed two of those 1K pots as speed dials for my turntable, I bought 4 of them just in case. When they arrived, I pulled my DMM and peasured each one of them. ALL 4 gave me values that are legit and steady. I will be happily using them. Hope the same happens on the rest of you when you are reading this.
J Vigg
2025-04-30 12:14:36
Standard 10Turn Pot with a Unique dial to indicate resistance. I did not find it all that useful tho
Darkoo
2025-03-23 15:08:25
It's durable and good material . I used it in my car close to the engine and heat.
A Puzzled Tinkerer
2025-02-06 10:43:23
Worked initially, but part way through the project I bought it for, something jammed inside, and then it quit working. Zero current, regardless of how you turn it.
Matthew W Murphy
2025-02-02 12:20:33
The media could not be loaded.
BAZ
2025-02-01 21:50:00
The device had solder on the tags and had already been used. Before fitting it I tested its functionality. The wire wound coil is open circuit. Using a multimeter I tracked the fault to about 5K ohms along the track. Not happy, looking for a more reliable component supplier in the UK.
Recommended Products
