Your cart is empty.
Your cart is empty. Specification:
Color: black
Material: hard rubber
Product Size: as seen as in detail picture
Package details:
10 x fader caps mixer
Note:
Due to manual measurement, the size and weight may have a certain error.
Due to the difference between different monitors, there may be a slight color difference existed.
levyroch
2025-08-17 18:31:32
I had a couple nightclubs, multiple rooms, and own a number of Pioneer, Denon & Allen Heath DJ mIxers. Their knobs typically come off from DJ use (abuse). These have retro-fitted all the mixers perfectly. And very cost effective.
Jay
2025-07-06 17:20:51
Great fit and quality!
Jared Savoy
2025-07-01 12:51:19
Bought these to replace a couple missing and heavily scratched sliders on a used Numark Mixtrack Pro II that I bought, I wasn't really a fan of the original silver/grey ones anyway. These fit perfectly and worked well.A couple of them fit a bit too close to the board, but a few minutes of light sanding on the bottoms to shorten them slightly did the trick!
Michael Van Fleet
2025-06-01 19:01:17
The cap holder was so shallow it didn’t fit my mixer.
OldSkool
2025-04-16 16:22:37
None of them fit the fader on my Mixars Duo cross-fader
Rich
2025-04-15 15:26:21
great product direct replacement
Andrew
2025-04-11 12:26:14
These caps are high quality and look identical to the original Pioneer mixer fader caps. They have a very professional look to them and would look great with most hardware mixers or synths. A 10-pack is just $7.99 at time of this review, so they are an excellent value for anyone needing replacement fader caps.
eric
2025-03-17 12:47:37
Package of 10 fader knobs. All the same size, fairly large and good for DJ equipment or anything that uses sliding potentiometers like a mixing console. These just push on and fit well as long as the slider pot is the correct size. These won't work very well on the smaller sliders.Good quality, they look as nice as the original ones and I'm happy with these overall.
Rob
2025-03-14 17:23:45
These worked very well on my vintage mixer.Felt and looked like it was the original.
mark caffrey
2025-01-24 11:07:08
Very fast delivery, very happy with the graphic slider knobs for my amplifier.
Mr Richard M Watts
2024-12-17 14:53:51
They do the job, but are not an exact match to the originals and feel a little lightweight / less robust. They are not bad for the price though.
Chris Harper
2024-12-07 12:16:08
Did not fit my djm500. The caps don’t clip on and are loose. They don’t sit above the faceplate of the mixer either. So they will take the white markings off if you use them.
Recommended Products
