Your cart is empty.
Your cart is empty.Product Description
Compatible Models
- For 1984-2023 Big Twin Touring Sportster Softail Dyna models
- For 1984-2023 Touring Electra Glide / Road Glide / Street Glide / Road King
- For 1984-2023 Sportster 883 / 1200 / Iron 883 / Iron 1200 / Superlow / Seven-Two / Forty-Eight
- For 1984-2023 Dyna Switchback / Super Glide / Street Bob / Fat Bob / Low rider / Wide Glide
- For 1984-2023 Softail Deluxe / Fat Boy / Heritage Softail / Softail Slim / Sport Glide / Street Bob / Breakout / Low Rider
- Do not Work with Harley V-rod
Exhaust Gasket Kit for Harley
High Quality Material
Made of graphite and steel mesh, easy to install, no leaks.
Perfectly Fit
- ID: 1.89 inch (48mm)
- OD: 1.64 inch (41.6mm)
- Thickness: 0.33 inch (8.4mm)
- Note: Due to manual measurement, it may be 1-2mm errors.
Package Included
- 10 pcs Exhaust Gasket
Charles B. Norris
August 2, 2025
Made job easier to do glad I purchased this well made tool
Tonya Latham
July 28, 2025
Served its purpose no issues
Al Ferguson
July 14, 2025
This is a must-have tool! It's well built and allows for perfect install of the soft head pipe seals. Simply place the seal on the tool and push the tool into the recess - no fuss. You could use the head nuts to run it in but not needed - it just presses the seals right in.
Rick
July 1, 2025
Comes in handy for seating exhaust gaskets well worth the price
R. Brown
June 2, 2025
The tool is a match for the tool that Jim's sells but for considerably less money. I have included pictures of a homemade handle that I pieced together from my local hardware store. 1/2 inch bolt,9 inches long, doesn't have to be grade 8. 1/2 inch nylon locking nut. The oring you will have to match up. I raided my old carburetor stash and found one that worked. My guess is you want a .5 od and thin. It has to go on the bolt and since there isn't a grove for it on the bolt it will overlap a thread. You want it to just hold the bolt in the tool. Thread the locking nut on the bold to cut threads in the nylon portion then reverse it so that the "washered" end is up against the tool. I have mine so that it goes almost all the way thru, about a 1/16" recessed. Put the seal on whatever end is correct and then the tool onto the studs and "lightly" tap the end of the handle until the tool hits the head.
Chase
May 15, 2025
The machining was good on this tool. I did have to drill the stud holes bigger to get it to fit on my studs.
Tony
March 21, 2025
Installing exhaust gaskets.
Panhead Dave
March 13, 2025
Makes replacing exhaust gaskets a breeze.
AJ
February 24, 2025
So far so good :)
Micheal R Newman
February 20, 2025
Good quality and work well.
Recommended Products
$13.99
$ 6 .99 $6.99