Your cart is empty.
Your cart is empty.
Features:
1. Made of high quality chrome-vanadium steel material, durable and long service life.
2. Transparent housing make it convenient to view the result clearly.
3. Great workmanship with 1/2 interface input, the calibration is clear to read
4. Metal base is more stable, 360 degree scale is marked in 2 degree increments
5. Suitable for tightening the torsion value of bolts or nuts such as bearing cover to more precise
Specification:
Condition: 100% Brand New
Material: Chrome-vanadium Steel
Drive Square Size: 1/2"
Package List:
1 * Torsion Angle Gauge
1 * Wrench
Mark Massingill
2025-08-14 16:59:45
This angle gauge works. It is much cheaper than a digital angle gauge and does take a little setup to use but it is accurate and performs perfectly when properly set up. As I rarely need such a device, I'm glad I didn't have to rig something DIY up (that may or may not have been accurate) or spend a ton of money to get a tool that does the job and does it quite well. I'm glad this inexpensive option exists. I'm very satisfied with the performance and price of the tool. It's not fancy but it works as it should and gets the job done.
titoluis
2025-07-30 12:28:35
Good quality and very easy to use. For a very small investment you will have an indispensable tool. Buy one you will use it over and over
Keems
2025-07-27 18:47:00
It works, but it feels cheap. Make sure you're not tilting it when using it. Find a sturdy place to put the l shaped steel so that it doesn't move and so that you can have an accurate reading.
Daniel Moore
2025-06-15 13:06:29
This piece of junk appears to work fine in your bare hands, with no load on it. But when you try to use it to torque a bolt, it slips and does not move the angle indicator correctly. You can seriously mess up your project if you don't notice the malfunction. It is a crappy design, relies on inconsistent friction from a rubber o-ring. The weak center joint allows it to tilt when under torque, causing the o-ring to slip. Don't waste your money. I saw similar advice on a review and bought it anyway. My mistake. Returning it.
Bill
2025-06-14 18:39:05
Haven't tried it tey but I'll Let you know
Customer
2025-06-02 13:09:29
Sort of works. couple times it wouldn't turn to indicate where you were at. working in an engine bay leaves very little clearance. Would probably be ok if you were working on an engine on a stand better.After using it I would probably just spend the extra money and get ARP bolts or studs just for my sanity.
Craig T Basch
2025-05-28 15:00:32
Good price
Travis L.
2025-05-18 15:21:16
If you're doing a head installation on an aluminum block LS engine you'll need an angle meter for the reinstall. Do NOT over torque your volts use this tool it's a pain in the a$$ but if you want it done right just buy a tool and do it
Rich
2025-01-08 10:21:26
L'outil fait ce qu'il est concu pour. Ok pour le mécanicien occasionnel. Bon prix, livraison rapide
Recommended Products
$43.65
$ 21 .99 $21.99
$29.87
$ 13 .99 $13.99
$39.97
$ 20 .99 $20.99