Shopping Cart

Your cart is empty.

Your cart is empty.

1/2' x 1/2' Male Flare Brass Tube Fitting for Propane, Fuel, Oil, LP and Natural Gas, 90 Degree Elbow (1-Pack)

4.9 (8) Write Review
Free shipping on orders over $29.99

$6.99

$ 3 .99 $3.99

In Stock

About this item

  • 1/2" male flare on both ends.
  • Suitable for propane, fuel, oil, air, liquid petroleum (LP) and natural gas.
  • Compatible with copper, brass, aluminum, and steel hydraulic tubing that can be flared.
  • Constructed from brass with high-temperature ductility and low magnetic permeability.
  • Contain low lead and prohibited to install for potable water use in the USA by federal law.


Product Description

1
1
Size 1/2" Male Flare x 1/2" Male Flare
Connector Type Elbow
Material Brass
Features Flare Fitting, Threaded Screw
Durability Rust Resistant, Leak Resistant
Applicable Media Propane, Fuel, Oil, LP Gas, Natural Gas
Applicable Pipe Brass, Copper, Aluminium, Steel Tubes
Application Hydraulic, Plumbing, Refrigeration, Vacuum, Pneumatic Systems
Temperature Range -65°F to +250°F (-53°C to +121°C)
Quantity 1 Pack
Exterior Finish Brass
Warm Tips Avoid over-tightening to prevent damage; Soap test to confirm the installation and prevent leaks.
3

SAE 45° fittings are designed for use on pipes of copper, brass, aluminum, or steel and are typically used in fuel equipment, plumbing, gases, refrigeration, and vacuum lines.


Kenneth Atkins
2025-09-02 15:42:31
Fit good at good price.
Robertomondo
2025-08-21 11:31:24
worked great
william oneal hicks
2025-08-12 20:11:11
Solid Brass fitting, fit well.
Rick&Les
2025-08-02 14:59:28
Well made product. Brass is clean, looks good. Threads are well cut, Sharp, no extra metal pieces, flare nuts screwed right on without problems. Perfect product for a 90° turn.
Keith Studer
2025-07-29 17:18:49
Perfect fit.
Nitin R. Goyal
2025-05-01 13:50:16
Usually don’t write reviews, but this one did deserve all stars. Looks good quality.
Daniel
2025-03-27 17:09:54
good
TGHamilton
2025-02-05 12:18:37
The threads are not cut deep enough for the flair end to seal. No compression on the flair.