Shopping Cart

Your cart is empty.

Your cart is empty.

12V Starter Solenoid Relay Switch Replacement 3 Terminals for Sten 435-700 Hus-qvarna 539101714 Trom-Betta 812-1221-211 854-1221-210 93265-9 93265WR 93265-WR

4.4 (8) Write Review
Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock

About this item

  • Replaces Part Number: 435-700, 539101714, 812-1221-211, 93265-9, 93265WR, 854-1221-210, 8541221210
  • The case is made of premium plastic and the contact material is copper-cadmium, which ensures maximum durability.
  • The relay uses a small voltage from the key to the closed contact on the high current relay of the starter.
  • Solenoid is grounded through the base, when bottom mounting bracket, if necessary, there is a slot for mounting the strap
  • Compatible with Hus-qvarna Z CZ EZ iZ 4217 4219 4619 4818 4819 LZ RZ Series


Product Description

Starter Solenoid 435-700

This is the replacement part of Husqvarna, used for lawn tractors/mowers.

When the ignition switch is turned to the start position, the starter solenoid valve engages and distributes battery power to the engine starter.

The most common reason for replacing a solenoid is when the engine cannot be started or even turned over and the battery is dead.

12VDC with 3 Terminal/ Ground Base, Horizontal Mounting Bracket, 5 / 16-24 Motor Stud, 5 / 16-24 Battery Stud, 10-32 Switch Terminal

SPECIFICATION

Unit Type: Solenoid For Lawn Mower Tractors
Voltage: 12 Volts
Number of Terminals: 3
Threaded Top Terminals: 1/4"
Connected: 1/4 Male Spade Terminal
Continuous Amps: 200
Surge Amps: 300
Duty Cycle: Intermittent
Compatibility 539101714 starter or power trim solenoid for Hus-qvarna Most Riders and Zero Turn mowers

Replaces OEM Part Number:

BLU-EBIRD: 539101714
HUS-QVARNA: 539101714
DIX-ON: 539101714
YA-ZOO: 539101714
TROM-BETTA: 854-1221-210, 8541221210

Installation Tips:

To replace the starter solenoid, you will need the following tools: Socket wrench, Screwdriver (flathead or Phillips), Wire cutters or strippers, Electrical tape or wire connectors.

Here are the steps to replace the starter solenoid:

  • Disconnect the spark plug wire to prevent any accidental starting of the engine.
  • Locate the starter solenoid on your mower. It is typically located near the battery or starter motor.
  • Use a socket wrench to remove the nuts or bolts securing the solenoid to the mower. Keep track of these fasteners as you will need them for the replacement.
  • Once the solenoid is loose, disconnect the wires attached to it. Take note of which wire goes to which terminal on the solenoid.
  • Remove the old solenoid from the mower. Take the new solenoid and attach the wires to their respective terminals. You may need to use wire connectors or electrical tape to secure the connections.
  • Place the new solenoid in the same position as the old one and secure it with the nuts or bolts that you previously removed.
  • Double-check all the connections and ensure they are tight and secure. Reconnect the spark plug wire.
  • Test the mower by starting the engine to ensure the new solenoid is working properly.

Dave Liepold
2025-08-08 13:50:18
Works great for a 2003 cudcadet 46” in lawn tractor.
Joe Smith
2025-07-29 19:26:23
Was very pleased with starter solenoid was very easy to install and fixed start problems.
Manny
2025-07-08 18:05:46
Works well
Penner
2025-06-30 13:13:56
Threads were slightly different on bolts from original, but no worries
Customer
2025-06-11 12:05:49
It fit my snapper 30” lawn mower and it worked.Good product at a good price
Reed family
2025-05-29 15:13:25
It fit my Mzt61 Husqvarna with a 30 hp Briggs and Stratton engine. We are slowly and methodically replacing parts to eliminate why it sometimes refuses to start and sometimes dies on me while mowing and then won't restart. Fingers crossed this was it.
Kyle Sullivan
2024-12-31 15:51:30
Garbage product. After installed, when attaching wires, the whole unit fell apart. Just garbage manufacturing and a waste of money.
Dennis
2024-12-02 09:10:36
This item shipped quickly and arrived in new condition. Installed and operates as expected.Would purchase again.
Recommended Products
Starter for Kawasaki Bayou 220 250 220A KLF220 KLF250 ATV 21163-1130 21163-1253 21163-1266

$33.99

$ 17 .99 $17.99

4.5
Select Option
FVRITO Alloy Easy Pull Recoil Start Starter Ignition Coil for 2 Stroke Engine 47cc 49cc 50cc SYX Taotao Coolster SSR MotoTec Chinese Mini ATV Quad 4 Wheeler Go kart Pit Dirt Pocket Bike Motor Black

$17.99

$ 7 .99 $7.99

4.4
Select Option
LOCOPOW GY6 Starter Solenoid Relay for 4-Stroke 50cc 110cc 125cc 150cc 200cc 250cc 90cc Chinese ATV Dirt Pit Bike Scooter Go Kart Quad Moped Taotao Roketa Coolster SSR Apollo Four Wheel Part Coleman

$8.58

$ 3 .99 $3.99

4.3
Select Option
Solenoid Starter Relay for Chinese Made 50cc 70cc 90cc 100cc 110cc 125cc ATV,Dirt Bike,GO-Kart,Pochet Bike,Chopper,Scooter

$7.99

$ 3 .99 $3.99

4.9
Select Option
AHL Starter Solenoid Relay for 4-Stroke GY6 Engine 50cc 70cc 90cc 100cc 150cc 200cc 250cc ATV Dirt Bikes Scooters Go Kart Dne Buggys Quad 4 Wheelers Pit Bike Moped Roketa SSR Taotao Sunl Coolster

$7.67

$ 2 .99 $2.99

4.6
Select Option
AHL Starter Solenoid Relay for Honda TRX400EX Sportrax 2002-2007 ATV / TRX300EX Sportrax 2001-2006 / TRX300EX FOURTRAX 1993-2003 / TRX400EX FOURTRAX 1999-2004

$7.88

$ 2 .99 $2.99

4.5
Select Option
GX340 GX390 Starter Motor w/Solenoid for Honda Electric Start Toro Dingo 11-13HP 128000-2750, 31210ZB80130, 31210ZE3013, 31210ZE30130, 31210-ZE3-023, DB5B6, DB5B8, SND0288, 41052044

$45.99

$ 21 .99 $21.99

4.5
Select Option
MOTOKU Starter Solenoid Relay for DVX 400 LTZ 400 QuadSport Z 2003-2008

$8.99

$ 3 .99 $3.99

4.4
Select Option