Your cart is empty.
Your cart is empty.Product Description
Quality Products
Quality Plastic Shell
- Flame retardant material, sturdy and durable.
Tunnel Terminal
- Large space, put the wire end in the middle of the terminal hole.
Silver Alloy Contacts
- Reduce the wear of the contacts.
- Improve electrical durability.
Installation
DIN Rail
- Install the 35mm DIN rail horizontally in a stable environment.
Installation
- Hang the circuit breaker slot on the DIN rail
- Push the lower end of the circuit breaker into the DIN rail
Dismounting
- Push the circuit breaker upward
- Turn the upper end of the circuit breaker out of the DIN rail
Joe, America Born and Raised. USA.
2025-09-06 17:02:45
These are good size. DC rated for solar. Fits a 4 gauge wire without any problems. When pulling 60 amps they do not get warm. There rated for 80 amps. I'm sure they will work for rated without any issues. I had other brand 60 amp units onAnd they got very hot. Never tripped but got hot. Almost 130 degrees, I have noticed that I'm getting more amps out of my 1000 watt panels. No loss going from point to point. Heat is loss of energy. I can bet we are getting 10 to 5 more amps because of the bigger contacts inside. No heat problems now. I always check tightness of all connections ever month so that wasn't an issue before. If your using some cheap CBAnd your system is getting hot replacement should be your first choice.
Barcox
2025-08-31 11:47:42
Works well. Nice quality.
Donnell Schweitzer
2025-07-04 10:50:18
Very good
Ariel Peralta
2025-04-14 12:03:32
buen producto
Moldy Brie
2025-02-19 10:41:03
Delivered on time and in good condition. Another CHTAIXI breaker for me. Use is RV battery isolator. Overcurrent is handled by the previously installed system. I just wanted a way to disconnect all loads when necessary for winter storage of battery. Breaker does this with an added line of protection. Thank you for making products to keep up with my ambitions!
pedro
2025-01-28 14:36:35
Producto de buena calidad
GS
2024-12-20 10:51:22
I like that this circuit breaker is a DC breaker and not one just labeled as DC. Single pole is much safer to use than dual pole DC breakers that may be fake units since the arc flash could cause a real problem (fire, etc.). I put this unit in line with a 60A MPPT controller using 4 AWG pure copper rather than CCA wire. Please note as other have that the clamping can come loose. I noted the same problem and had to really crank down the the tension after seeing the clamp came loose on installation. I won't be purchasing more from this manufacturer and most likely will go with Square D QO for DC circuits in the home
INDRO M.
2024-12-06 16:03:18
De fácil instalación , funcional y discreto. Excelente
Recommended Products