Your cart is empty.
Your cart is empty. Product Specification:
Shank Diameter: 1/4 inch
Cutting Diameter: 1/4 inch
Cut Length: 1 inch
Overall Length: 2-1/2 inch
Design: 2 Flute Spiral Plunge cut
Material: Solid Carbide
Coated: nACo Coating
Performance
★ The ‘Up-cut’ end mills shear in a downward direction causing the uppermost layer of the material to be pressed down against the material just below it. This motion leaves a perfectly clean top surface edge. but A concentration of wood chips in the work path will occur. clear excess wood chips to prevent bit breakage.
★ nACo coating provides longevity and produces cutting results of the highest quality.
★ use for cutting: Laminate, Melamine Particle Board,MDF,Veneered Plywood,Wood
Warranty For Customers
Lifetime Warranty
12 months money back guarantee or exchange
if there are any problem with the item please contact us at first, we will offer new item exchange or refund policy.
Customer
2025-08-25 12:32:22
Have only used it a few times but cuts great. We will see how it holds up in the long run but great so far.
Customer
2025-08-16 13:45:59
it worked
Bret
2025-07-27 18:44:40
I have used this brand before and these, like those, work fine.
Shaun
2025-07-15 15:46:45
Good bit, was kinda iffy of the name brand but hey this thing cuts great. Soft & hard wood no problem, have been using it for a couple months now & its still sharp.
Francis Coutou
2025-06-29 10:02:29
Used on a one time project, worked great, it did good job of cutting and removing the waste material.
jeffbrown
2025-06-23 16:54:35
Good price point and great results
D. Paulsen
2025-06-19 15:26:11
The downward spiral design makes a smooth cut, leaving very little chipping or tare out. I use these for delicate small jobs, and they work great. However, they are small and brittle from the hardening process, so be careful not to bump or bend the bits (they will break).
Outletsales
2025-06-03 17:03:48
Flute too shallow. Does not remove enough material. Bit overheats.
Customer
2025-03-09 11:16:45
I am using this bit to cut hardwood on my CNC router, really impressed at how sharp it is and how clean it cuts.It's so sharp I actually got cut just handling it gently during a bit change, so maybe handle with gloves...Really happy, ordering more.
Mr R Jackson
2025-03-05 15:53:47
Used to make a template to route an odd shaped loudspeaker driver.I have used it a few times now for other circle cutting and seems to be holding up well only taking 3 to 4 mm cuts which seems to work well.
Mark Christie
2025-01-25 12:03:40
Title says it all, very sharp and very efficient
Marc
2024-12-15 17:20:45
work super well
Marc Roy
2024-12-03 21:29:52
I am impressed so far I want to see its durrabilty
Recommended Products
