Your cart is empty.
Your cart is empty. "Rear Wing Spoiler LED 3rd Brake Light fits many Spoiler on domestic and foreign cars.
Please make sure the Length (15.5 inches), Shape (Quarter Round) and Mounting type are correct.
No instruction included
Professional installation is recommended."
Steve S.
2025-05-25 15:17:55
Put on a Snug top shell on a 2004 Ram CC, installed about 5 years ago and still working, all in all would buy again, although it is a bit pricey, would not pass VA. Inspection without third brake light.
FubarSir
2025-04-26 17:36:28
Fits PERFECTLY in my Toyota Snug Top. Took about 30 minutes. Remove left tail light cover, replaced fuse in line. Install new light. Saved about $110.00 doing it myself!
Sean M. Scott
2025-02-15 14:53:49
Works well. Fast shipping.
M. Robinson
2025-02-01 16:21:42
Pricey when compared to generic lights available, but none of those would look factory, so I bit the bullet and ordered this one. Simple two wire hook up. The original light on my Snugtop Expo shell deteriorated and broke into pieces years ago. Didn't realize third brake lights , if the vehicle is so equipped, have to be functional, so I went for this.
Sean D.
2024-12-24 16:58:19
Perfect match replacement and super easy installation!
Quiet C.
2024-12-21 15:06:05
Perfect replacement for my new-to-me Snugtop topper. Wired up and worked great. Note, these lights are installed with adhesive tape instead of any kind of hardware so you’ll need to pry off the old one and use 3m double sided tape to install this new one. It does not come with adhesive tape.
The Dude
2024-12-13 15:00:32
This light was a good replacement for my SnugTop original tail light.It's relatively easy to install, but there is no adhesive on the unit at all nor does it come with any double sided tape or anything like that.I used a flexible adhesive I had in the garage. Easy enough.I bet something like mighty tape would work well also.The price is a little high for what it is, but it's also the only one I could find and I'm happy to have the tail light operational (and no longer faded) again.
Husband
2024-11-27 16:05:59
This was the only option that I found for my snugtop camper shell. It fits just fine. I got a roll of 3M automotive double side tape, about 1†wide, and ended up putting like 4 layers to make a tall flat base to set the light, also used transparent silicone all around once I was done with the cable inside the cab. It works great.
Recommended Products
