Your cart is empty.
Your cart is empty.Product Description
16Amp AC/DC 2x12 Position Terminal Block Distribution Module
Product Description
- 16Amp 48V 2x12 position terminal block distribution module. Support for multiple module extension connections.
- Rated current 16 Amp(total input or output), Maximum voltage 48V AC or DC.
- A / B Screw terminal blocks, Pitch 7.5mm/0.295", Wire range 26AWG ~ 12AWG / 2.5mm square. Rated current 16 Amp. Strip length 7mm. Screws - M3,steel, Cr3+ Zn plated. Pin header and Cage - Brass.
- A1~B6 / A7~B12 Screwless terminal blocks, Pitch 3.5mm/0.138", Wire range 26AWG ~ 20AWG / 0.75mm square. Rated current 2 Amp(for each positon). Strip length 8mm. For the screwless terminals, you can use your fingers or a screwdriver to press the top button, then fill the wire conductor into the hole and release the button, which is very convenient.
- UL CE CQC certified terminal blocks, FR-4 glass fiber PCB.
M.
2025-07-26 12:37:50
The module showed up well packaged and worked as advertised, it’s being used to split up closet led strip lighting
Computer Science Laboratories
2025-07-21 12:15:28
It's very small, it has push in compression terminals. It works good. I'm happy with it. It WILL NOT WORK WITH FERULES. Tferules are not long enough. You have to strip the wire some length.
Rob 'n Julie C
2025-06-24 13:26:31
Installed with no issue. Found that push buttons were a little bit fiddly when trying to grip very fine wire (probably 30 AWG or finer) since the wire tended to bunch up if push button wasn't fully depressed and wire was inserted "dead on". I suspect that tinning the wire with solder would cure my issue. And I'm sure that heavier gauge wire or solid core wire would be just fine. I'm using my to distribute 12V DC power to about 10-15 lights on the bottom of a train board. Ended up daisy-chaining two of them to get to different parts of the board. Would buy again.
No Name
2025-05-22 20:07:50
Push release works perfectly
Homebrew
2025-05-20 14:40:36
very very small read specifications carefully
William Parish
2025-05-07 14:56:44
Contrary to the picture these aren't screw terminals but push contacts, but they work well for my use. I can break out my pc power supply 5v line and branch off several pi's. I have a second one for the 12v line that I use for the switch (and other pi's with a dc 2 dc converter to drop the 12 to 5 v). Using these I can power all the pi's in my bramble, and their switch, with a single PC power supply.
Matt K.
2025-03-26 18:21:12
Worked well for what I needed to develop a prototype.
Ted Brukiewa
2025-03-01 17:12:32
The item is very small, a little over three inches, it looks good just appears that it will be difficult to work with. I am returning it.
Rene A. Dieck H.
2025-02-20 11:47:05
Muy bueno
Recommended Products
$34.99
$ 15 .99 $15.99