Your cart is empty.
Your cart is empty.Designed for a guaranteed fit, this high quality custom fit latch cable is made from the finest materials. Better than OEM quality! Easy installation. Compatible with Ford: 1997 - 2002 Expedition Liftgate Cable. Reference Info: F2UZ-15264A65-B, F2UZ15264A65B.
Customer
2025-08-09 11:26:40
So, after struggling with improperly sized metal replacement ends for several hours Friday evening, I ordered two of these cables Friday night for $19 each to repair my tailgate and window . THEY arrived SUNDAY at noon time, and were installed by Sunday evening. It's a bit of a struggle to get them installed due to lack of working room, but if you take pictures of how the cables are routed as a reminder and then unbolt the latch assemblies and take your time, it is doable. It helps to have a second person hold the tailgate open, hand you screws, etc. Be careful when working with the glass window latch assembly. It is easy to accidently disconnect the door ajar sensor during cable replacement. Make sure that the door ajar sensors are working properly and shutting off the interior lights, etc. when you close the tailgates before putting the finish panel back in place. Hope this helps.
Sphez
2025-07-09 19:25:59
It fits perfectly. Not hard to install. Here's how I installed it.Pop liftgate interior panel off. Two screws behind grab handle, then pull from bottom. Lots of panel fasteners to pop out - then lift off where latch is. Pull of plastic water barrier liner.Remove rear wiper blade, then remove wiper motor - unplug connector. (lots of YouTubes on this)Take three screws out of handle latch mechanism and detach hatch and glass release cables.Unplug glass hatch latch mechanism, the remove four T27 Torx screws holding in in place.Slide mechanism out and take to workbench.With pliers and a vise, bend tab out that holds cable top end in place. Remover old cable. Insert new cable and bend tab back.Reassemble everything in reverse order.
Wm Landrum
2025-06-18 11:33:41
Cables worked great. My cable stays were broken causing door ajar light to come on every time I opened or closed the hatch door or window. Then my window would not open. The replacement of the cables solved those problems. I may have put the cables on backwards because the white end was really tight and the black end was loose enough that I had to use pliers to squeeze the holder together just a bit to ensure the end did not come out of the holder. I did not measure to see if there was a difference in the size of the ends but that is something you may want to check before you install yours.
Dean
2025-06-03 16:58:59
Good product
Customer
2025-04-28 13:02:14
Just have to take the latch off and bend the tab and install the cable.
Michael Clarke
2025-04-06 10:03:44
I installed both window and tailgate cables and they both work perfectly!After reading the reviews on other options .... i.e. the aluminium pieces you can add, I decided to not bother and just get the cables.The window one is a challenge as you need to bend a steel tag on the assembly to remove and replace the cable. If you have a bench vise it is easy enough.That being said it is not an easy job!!
Mike Spradlin
2025-04-04 14:40:29
Great quality. great product at a good price
Ironeagle
2025-02-05 10:12:14
Same cable for the hatch same cable for the window 2001 Ford expedition fit perfectlyWindow is a bit tricky but was very pleased
Recommended Products
