Your cart is empty.
Your cart is empty. EPLZON GY-521 MPU6050 Module with DuPont cable kit
Specification:
☀Model: GY-521
☀Main chip: MPU-6050
☀Communication method: standard IIC communication protocol
☀Power supply: 3-5v (internal low dropout regulator)
☀Pin pitch: 2.54 mm
☀Material: PCB
☀Gyroscope range: ±250 500 1000 2000°/s
☀Acceleration range: ±2±4±8±16g
☀Chip built-in 16bit converter, 16bit data output
This project is to set up MPU-6050 module 3-axis gyroscope accelerometer module, compatible with Arduino and Raspberry Pi.
MPU-6050 module adopts standard IIC communication protocol for communication, adopts 3V-5V power supply, and can be used continuously.
This module is ideal for Arduino and Raspberry Pi compatible experimental and model structures.
Package Included:
▶1 x MPU-6050 3-axis Accelerometer Gyro Sensor Module
▶2 x pin headers
▶1 x female-male DuPont cable
▶1 x female-female DuPont cable
notes:
The above mentioned brand names and any related model numbers are used to demonstrate compatibility only.
Michael Marshburn
2025-07-02 11:48:52
I had an issue when connecting the very first one. Couldn't identify it on I2C. Had to prep both of the others by soldering the heads on to try them out. Both of those are good and will function. So, be prepared that some or all of these may not work. Haven't had a chance to see the margin of error in them.***Update. Only 1 of the 2 that were recognized through I2c would provide *accurate data. The second wouldn't register alterations of position. So, 2/3 of these were of no use to me.
Frank
2025-02-23 18:44:59
only one of them barely registered any movement in the y-axis, nothing in x or z. one of them wasn't even detectable over i2c. pretty disappointing :(
Quoc Dang
2024-12-08 12:58:45
the jumper wire is not connected to the board, the connection need to be soldered to be secure.When I rest it stably on a table, it experience some drifting effects.
Recommended Products
