Your cart is empty.
Your cart is empty.S. Armstrong
2025-08-15 14:29:56
I use these dispensers to hold isopropyl alcohol. It makes it real easy to load up cotton swaps with the alcohol when I am cleaning electronics like flux off of circuit boards. The lid is secure and the pump works very well.
POTA Ham
2025-05-14 14:06:32
It works as it should and the price was right.
Keith
2025-04-27 10:41:17
Useless, ended up in the trash within ten minutes of receiving. Filled with IPA. The cheap plastic combined with rigid metal top creates no seal. The plastic is so thin you can almost poke a nail through it, can’t possibly be chemical grade. I’d imagine anything stronger than IPA would eat right through it. Doesn’t net any convenience, as intended. IPA was all over the side of the bottle with the slightest pump.
DBM
2025-04-10 15:04:50
At first, the plunger tops seemed to stick a lot. Often the top would not easily depress first time. Was annoying. They are now over a year old and work better. Maybe I am better at using them?
Jason
2025-04-05 18:02:29
The plastic suction tube was broken before I was even able to use it. I flipped it around and it worked but still this shouldn't be an issue. The other seems to be doing okay. I have four of these from this vendor and one straw failed.
Jeff
2025-02-22 16:12:26
Seems to work as well as the more expensive name brand units but is less expensive. Does what it is supposed to!
CoMo
2025-02-20 10:48:35
These alcohol dispensers are super cute, but the straw on every single one has now broken. That makes the pump feature not work. I'd gladly pay a little higher price to have better quality straws so that I'm not stuck with four unusable alcohol dispensers.
lstidham
2025-02-13 13:26:13
works really well. very sturdy and easy to use with one hand. new diabetic routine means lots of alcohol and finger sticks, so this is perfect. i like this because it looks like glass.
Sange
2025-02-07 09:59:38
Good quality plastic
Mark Todd
2025-01-27 10:29:33
bad fitting lid, oversize thread, difficult to line up with barely 360 degree to tighten, non sealing cap. Pay a little more & you should get better quality.
Tim Hunter
2025-01-24 16:05:16
Cheap plastic moulding - lid can't be tightened and therefore don't actually work.
Isabella Cornea
2025-01-23 19:19:47
They just seriously don’t work and are really bad quality, the lid always rattles- heaps of problems
Tanja R.
2024-11-16 10:54:44
Poor product.Lid is poorly made.Leaks and squirts all over the place.Do not recommend.
Recommended Products