Shopping Cart

Your cart is empty.

Your cart is empty.

2 Sets Trailer Axle Nut Kit Combination for 1' Shaft Spindle Includes 1' Shaft Spindle Nuts 1' Trailer Spindle Washers & 2.2' Long Cotter Pins, for Trailer, RV and Boats

4.3 (3) Write Review
Free shipping on orders over $29.99

$6.99

$ 2 .99 $2.99

In Stock

1.Size:Yt-pj0001


About this item

  • Compatibility: Fits 1 inch shaft spindle trailer axle.
  • Kits include: Two 2.2 inch long cotter pins,Two Inner diameter 1 inch Trailer nuts, Two Inner diameter 1 inch washers.
  • High quality: The trailer nut kit are made of premium stainless steel which is corrosion-resistant and wear-resistant, so you can even use them in saltwater, greatly extending the usage of life.
  • Easy to Install and Remove: The trailer nut has smooth and deep threads, easy to install. While the cotter pins are 2.2’’ Inch long for you to install them easily and cut them to length. After testing, it can fully cooperate with the original equipment, very convenient to replace and install.
  • Scope of Application: The trailer axle nut kit can be applied to caravan, RV and trailers hubs as well as boat trailer hub, including yachts, rubber dinghy, motorboat, aluminium boat and roadrunner.
  • Please Note: Please check the size information and compatibility carefully before placing an order.


Product Description

Trailer Axle Hub Wheel Grease Seals

Bill B
2025-08-20 17:07:14
I ordered this kit to replace a damaged seal on a new 3500 lb axle hub and drum assembly and it fit fine. The seals all look good, well packaged and lightly oiled with no signs of blemishes or surface rusting as you might see with older stock.
R.M
2025-03-01 15:13:30
If you have a newer axle on your trailer that has the grease buddy zirks in the hub, the cotter pins will be too big and wont work. If you have an axle with a straight through hole on the end of the spindle, this should work fine.The spindles with the grease buddies have an offset hole and require a thinned cotter pin, so these thicker ones wont fit.Just a heads up for you all.
Mr. Sixx
2024-12-05 17:50:10
I have been using these for a few years now and they seem to work great. They are pretty close to the Dexter seals and are cheaper. I also got these and they are just about the same as the Libra seals at an equivalent price.These shluyistx seals have the right dimensions, but seem to be different from the Libra and FDXFYH seals. I have in the pictures the Libra seals on top, FDXGYH on the lower right, and shlusycatx ones on the lower left. I noticed that the spring on these seals was a little thinner and more stretchy than the other two. There's a close up with shliyast one on the left and the larger FDSXNY one on the right. There is also some stamped part number info on the outside of the rubber seal on the first two, but nothing on this shldydastx one.So I'm thinking I would get the Libra or FDXHCY one over this one, due to the stronger spring and more info on the rubber part.