Your cart is empty.
Your cart is empty.Reduce body roll, understeer and generally sloppy handling with one of these ADDCO Anti-Sway Bar Kits. The bar is made from high carbon steel and is hardened and stress relieved to give your suspension superior support during sudden or sharp turns. This bar must be used if you have an existing bar on your vehicle. This bar is larger in diameter than the factory bar but uses the same mounting points as the original factory bar. It requires the use of the special hardware that was factory installed. This kit may not contain all the hardware that is required for installation. This cannot be used without the original hardware.
Mark B
2025-08-11 11:49:35
After installation of the stabilizer bar I was having issues with the end links lining up as they should. So I removed the bar and took some angle measurements on the bend areas. Much to my surprise, the bend were not the same left side, to right side. The angles were off by almost +/- 10 degrees or so. To some, that may not seem like much. But on an automotive application, that's a lot. Easy comparison for ya. That's like having a 12 foot tall tree in a house with an 8 foot high ceilings. I'm currently in contact with Addco about this issue.
Recommended Products
