Your cart is empty.
Your cart is empty.Product Description
Jeffrey N.
2025-09-05 18:11:03
I had zero luck with a traditional easy-out bit and this Worked amazing on a torx head bolt. Works great for stripped head probably not for broke off bolts.
Noelle
2025-07-20 15:55:10
Not bad for what they are. Make sure you use them properly. After frequent use they will wear out, that's just how it is with these softer metal low cost kits. Great to have for when you are in a pinch, just do not expect them to be a lifetime kit.
L. Dwernychuk
2025-06-19 13:36:04
It worked as a should I was able to tap it in the broken fitting and then put a half inch ratchet wrench on the back I was able to back out the broken fitting. The hardest part was removing the broken fitting from the easy out after I finished.
Jax
2025-06-14 15:17:29
I haven’t used them yet but very nice product n guys at work on pad love the product from their use of them always top notch!!!!
2020
2025-06-02 18:32:46
It didn’t work .
Boris falls
2025-05-08 10:45:33
I like it 👌
Dave Stanzito
2024-12-31 18:46:18
These aren't American made. That's fairly evident if you've been around hand tools long enough. Which isn't to say they are bad, but they are knockoffs of much more expensive ones. If you want to use a socket wrench or butterfly to chase tapped holes, these work fine. I'd be leery about using an impact on them for serious amounts of time. I think they spring would be the potential failure point. But, from a tool maker perspective, these are a good value. It's definitely a setup up from my homemade version where I plug welded a hand tap handle into a socket!
gisela
2024-12-13 11:22:37
Muy bieno
Recommended Products