Your cart is empty.
Your cart is empty.Product Description
Parameter:
- Input Voltage: DC 3 V to 6 V
- Input Current: 2 A - 5 A
- High Pressure Type: the Type of Pulse Current
- Output Voltage: 400000 V(Please Pay Attention to Safety)
- High Pressure Discharge Distance Between: 10 mm - 20 mm
- The Output High Voltage Wire Length: 100 mm
- Input Power Cord Length: 100 mm (Red Line is Positive)
- Wiring:Red and Green Power Connection Red Line:"+" Green line "-"
- Output: The Other Side ,Same Color Cable
Attenton:
- The High-Voltage Module Should Avoid The Use of Electricity in High Voltage No-Load (Power Must Be Adjusted to a Suitable Distance to the High-Voltage Output Line , Battery Capacity is Proportional to the Distance and the use of the High-Pressure Arc( NOT a Voltage as High as Possible , You Must Provide Enough Current ) . Experimental Test of the Arc Distance from Short to Long , Do NOT Exceed the Maximum Arc Distance Electricity, Energy Can NOT Be Released Due to High Pressure , Can Easily Damage the Module. )
- Work:Intermittent , Continuous Work Does Not Allow More Than 1 Minute and the Output Side Does Not Allow Shorting . Improper Voltage and Long Working Hours Easily Damaged The Module
Oopzz
2025-08-20 13:39:22
Whatever you're building if you need one of these I recommend it thank you.
TangoZulu
2025-08-08 09:44:34
I purchased a 5 pack of these dynamos. I attached a nine volt battery to the black and red (line) leads, but there was no current at the other (load) end. I tested all five with two batteries. Then I tested all 5 with a multi meter and found no flow of electricity from one side of the dynamo to the other. There was however, continuity from the black lead to the red lead. This was true for every voltage generator. I returned that first five and quickly received another five. All of these new ones tested identically to the previous five. It looks to me as if they have a defective manufacturing process and no quality control.I would like to retract this review. I used a fresh battery and ended up shocking myself.
Nate Lancello
2025-08-04 16:38:30
I mean, yeah. It's a taser. Probably hurts like a mother.I recommend a single 3.7v lithium battery like either of the two in the image.These can deal with the significant current draw the device likes, and should not overvolt it in my experience.Keep the output leads less than a half inch away when getting things set. If there are too far away, you're gonna destroy the device. So start with a small gap and work your way up.With a 1.5 inch gap this thing snaps about as loud as a .22, likely louder than some. A nice intimidating crack like ripping a sheet of paper. Easily 1-2 a second with a good battery.Good qualities for self defense should one want to go that way.
Anonymous
2025-08-01 19:43:38
The media could not be loaded.
kenneth guzowski
2025-06-21 11:29:22
The media could not be loaded.
Markel Kozyrev
2025-05-20 14:01:59
guys you should 100% buy this because its making an 1-1.5 cm arc from a single doble a battery
Jason
2025-02-21 15:06:59
These are the best option for upgrading your potato cannon ignition. They really kick it up a notch!
Placeholder
2025-02-01 12:21:41
The first one fried after half a dozen arcs. Hopefully number two does better!
Jorge Benito Rodriguez Martinez
2024-12-25 13:09:37
Es lo que ocupaba a precio justo
Recommended Products