Your cart is empty.
Your cart is empty.jim
2025-09-04 13:36:57
WE added a wireless ( 4 ) microphone system to a single antenna. Church application , Very good coverage.I see why the special connectors , keeps untrained from screwing up the Impedance of the system adding mismatch wires.
Josh
2025-08-29 17:03:13
I use this to split my attic-mounted antenna between two SDS200 scanners. It works fantastic, and as far as I can see, I didn't lose any signal strength on my devices. I would recommend this product to anyone needing to split an antenna feed.
Leonard Trembley
2025-08-05 15:18:39
This has worked surprisingly well as a Splitter for my two High-end AOR LF to UHF Scanner/Receivers. I know this is only rated from 5Mhz to 1Ghz range, but it has less than 3db (standard splitter) loss from 385khz LF to 1.2 Ghz. Highly recommended. N7FAE
Salado
2025-07-06 13:53:11
used it for almost a year and one of the wires started to not work unless I moved it around a bit. no big deal ill just replace the wire and make another... except the push on connectors are very uncommon for sdr/scanner/radios.I believe its a PLA or PAL Male push on. too bad they didn't use BNC or SMA for all connections. Overall its has worked well, I just wore out 1 wire from always swapping it from a SDRplay to a handheld scanner.I'll just have to use this "F-Type TV Aerial Coaxial Coupler Female to Male Antenna CATV RF Coaxial Adapter Connector" then to "F Male to SMA Male" to a SMA cord. Too many connections for my liking.
Fred Swift
2025-06-21 17:14:29
came with all the inter connect cabling.the splitter outputs are not BNC's
matthew
2025-05-28 12:58:14
it kills my Signal
Jason
2025-01-31 10:19:17
Went back to the strisberg multi coupler.Difference is night and day
Thomas Moore
2025-01-12 11:41:21
very good
Recommended Products
$14.99
$ 7 .99 $7.99
$875.00
$ 99 .00 $99.00