Your cart is empty.
Your cart is empty.Product Description
4 Pack Wire Brush Set for Drill
- Materials: Stainless steel wire + Metal.
- Shank diameter: 1/4-Inch Shank
- Sizes: 3 " twist cup brush, 3 " copper-plated wire cup brush , 1" knot pen brush, 1" copper-plated pen brush
- Use for: Removing Rust/Corrosion/Paint
High Quality
Made of heavy duty High-Carbon 0.3 MM stainless steel wire, the wire wheel for drill is very strong with a long service life.
Sharp & Sturdy
Hack down rust and old paint efficiently making it ready for metal primer after a wipe down. High-density uniform steel wire is tight and long-lasting, leaving a uniform, smooth surface.Innovative spiral knotted and Crimped wires brush construction.
Satisfy Your Various Need
Contain 4PCS. The konted wire brush for heavy deburring, the copper-plated wire brush for gentle grinding. The cup brush for large area grinding, pen brush for narrow conner,which can clean thoroughly without residual stains.
Warm Tip:
1. When installing the grinding head, please make sure the chuck can hold 6mm shank. Meanwhile, you can use a special wrench to tighten properly and check whether it is firm and strong.
2.For your safty, please make sure you wear SAFETY equipment such as a face shield (or Full Coverage Goggles) and gloves.
3. During the grinding, the operator should stand on top of the workpiece to prevent it from flying, chipping and hurt.Use the grinding head, the force should be increase slowly.
Kevin Thomas
2025-07-08 21:01:44
As Advertised
Designer Digital
2025-07-06 18:00:32
I just used the silver strong scrapper and did my whole gate system, and it is intact!!!! All rust, paint, mud, gone!!! I just dealt with swapping my batteries. Amazing!!!!!!
dmage
2025-06-12 16:51:13
I didn't notice in the picture and there's really no explicit reference to the heavy duty 1 in knotted wire wheel having a regular bit rather than the hex connector like the rest. What's even the point of making one of them an oddball. So the severely limits functionality, and is not a good value because I had to go out and buy a second set to replace this one.
Malcolm Shealor
2025-04-14 11:24:43
Good value
Dana
2025-04-09 10:05:58
All of the brushes work really well. I used them to clear rust off of some iron skillets, which have angles and divots that these cleared through with ease. All of the brushes had a hexagonal bit for the drill to grab on to, except one, which was cylindrical. That one still worked, but came loose a little easier than those with the hex.
Frank V.
2025-04-01 16:09:50
Worked good removing rust from wheels
Coty_G
2025-03-14 17:27:48
Solid products for the money! One piece doesn’t fit drills with those hex stud ends!
Jessica
2025-01-04 19:31:39
I used this to remove loose paint on my deck. It really sped up the job!
Recommended Products
$22.57
$ 10 .99 $10.99