Your cart is empty.
Your cart is empty.
3 Inch Wide Pneumatic Chisel Bit
Material: high quality drop forged steel alloy
Dimension: 3"(75mm) wide, 7.5"(19mm) long
Design: One-piece body design, machine sharpened,designed specifically for high impact stresses, hard and durable with long life time
Shank: 0.401 inch shank for air hammers
Compatibility: Compatible with all standard 0.401 inch air hammers and air chisel hammers, including Ingersoll Rand Air Hammer, IR Air, Milwaukee Air Hammer and Dewalt Air Tools, etc
Aric Pennington
2025-04-13 11:54:47
Used with air hammer to remove tile and thin set. Made the job flow faster. Great tool to have.
Richard 559
2025-03-21 10:29:04
I liked the speed at which the tool worked.It also had a precision cutting ability.I wish I would’ve used this a lot sooner.It made the job go by much faster and easier.My advice is to start with this tool in the beginning of your demolition project.
dawn zurybida
2025-01-31 18:50:39
The price was good & my son=in-law who used it to removes ceramic floor tiles was very happy, he said it took no time, plenty sharp
NC
2024-12-26 14:05:32
I bought this to chip up 9"x9" glued-down fake wood laminate tile in my living room. This chisel works great IF you've got a good air compressor that can put out some air. I've got a California Air Tools 8010A 8 gallon 1hp compressor. The chisel worked great, but only when the air compressor was at sufficient PSI. Definitely not the tool's fault. The only thing I don't like about this tool is the angle. I wish the angle was more swooped downwards so you could really get under the tiles. The blade on this tool is double sided. I think if one side was left flat and the angle was more aggressive that you could get under the tiles better. I think that this is a great universal chisel though (not specifically for tile), but like I said earlier - it did GREAT when my air compressor had sufficient pressure (80% of more). I think as long as your compressor is more than 8gals/1hp you'll be totally fine with this chisel.
Shoe H.
2024-12-01 20:30:35
Had to rip up some vinyl flooring with lanolium and ripped it up with no problem, right through to the concreteWish i new this before i did the other rooms
Bobotron
2024-11-29 10:15:54
The media could not be loaded.
G SHOTTS
2024-11-23 15:16:01
It works great, even rusty. This is more for your information if you get it wet it will rust in one day, then you'll have to sand it down to put it back in your air hammer.
Recommended Products
