Your cart is empty.
Your cart is empty.Product Description
WIDE COMPATIBILITY
Our Thermal Fuse fits Whirlpool, Kenmore, Maytag Washers and more
NON-CRACKING DESIGN
This Thermal Fuse is made of sturdy ABS platsic which is strong and wear-resistant, enhancing durability
BEST SOLUTION
BlueStars brings DIY solutions to help you deal with any trouble
SIMPLE INSTALLATION
Just 5 minutes of replacing to make your Dryer run like new!
JJC
2025-09-04 17:08:45
Very easy to install. Super simple and it works as intended. Quality seems good so far. Time will tell how good it works, but for now it’s doing the job just fine. Very affordable if you know how to install it yourself.
Christopher F
2025-08-25 15:28:45
It was a quick, cheap, easy fix & now my dryer works good as new.
mark b
2025-08-07 14:52:41
The first thing my wife noticed was that the dryer wasn't shutting off....just kept on going until you opened the door (even after 3 hours.) Then we noticed there was no HEAT inside the dryer. Ugh, what's this?After a little bit of an internet search about these problems in general, and our old Whirlpool gas dryer, circa 2000 (model number LGR3624JQ0) I found that this thermal fuse is usually the most likely culprit...and should be a quick and inexpensive fix. Can it be??So, finding the correct part here on Amazon from BlueStars for $5.94, I thought why not give it a try? Following some instructions found on YouTube after the part arrived 2 days later, I got busy. Unplugging the dryer, scooching it out from the wall (ours is gas, but fortunately we have a long enough gas line that I could pull the dryer out far enough to get behind it and work without having to disconnect the line.)Using a 1/4-inch socket, I took out all of the 9 or so screws all around the back panel and set it aside. I also had to disconnect the dryer vent--that ended up being the worst part of the job, more on that in a bit. Setting the back panel aside, I was able to easily find the thermal fuse. Removed the 2 wires connected to it, and using the 1/4-inch socket, removed the single screw holding it. Reversed everything from here, and that's when the dryer vent hose got to be a royal pain. The stubby little pipe that sticks out the back of the dryer, just past the back panel only by about a 1/2-inch, it seems. Getting the hose slipped on that tiny area and the clamp tightened down to hold the hose to the vent pipe was umm, challenging to say the least. After several atttempts and many curse words later, I finally *did* get it done. I held it firmly while my wife gently pushed the dryer back into place.But this was really an easy job, overall...and miraculously, this really CHEAP part cured everything! Dryer is working again, flawlessly. I don't know how much that would've cost to have fixed, but I know it would have been MANY, MANY TIMES over the less-than-six-bucks that I spent.If you've never done anything like this before (I hadn't) don't be overwhelmed. These things aren't that complicated or as daunting as they may seem at first. I also replaced the drum belt, idler pulley, and rear drum rollers immediately after doing the fuse--but that's another review (and another relatively easy repair!) With just a little bit of research and the right attitude, you can save yourself a ton of money, and have the satisfaction of knowing that you are a bit more self-sufficient!Good luck....and good...drying! :)
Sarah Posey
2025-07-31 17:45:57
My husband ordered this thermal fuse for our dryer. It fixed our problem and arrived fast. This was the best price I was able to find on this product.
Tien Hsin Cheng
2025-07-17 12:35:23
I got Kenmore Gas Dryer. I replaced this parts for the original parts. It's working well. My gas dryer is back to normal with heat.
Curtis M
2025-06-20 10:43:42
First time ordering this product, hope it last a while, that is why I gave it four stars.
Buck
2025-06-06 12:38:04
Good fit. works well
Customer
2025-05-27 19:35:50
This little thing saved me from throwing out my dryer. I took old one out myself and replaced the new one. Simple and very easy to install
Anthony King
2025-05-14 16:43:25
Easy install. Works well
Brian Gander
2025-03-31 14:12:55
all was good and worked good fit good came on time.
Alexandre A.
2025-02-24 18:28:44
J'ai économisé l'achat d'une nouvelle sécheuse grâce à cette pièce de rechange! Trop content!!!
Customer
2025-02-10 12:36:02
Good product, accurate description allowed me to easily pick the right model for my dryer. It however blew again after 2 days, but I do no think it is because of a faulty fuse. Probably the heating unit is faulty and creates a surge that keeps blowing the thermal fuse.
Jennifer
2025-02-08 16:50:31
Fit perfectly. Easy to install and would buy again
Recommended Products