Your cart is empty.
Your cart is empty.Air Compressor Water Separator Installation steps:
- The assembly of all calibration shall meet the maximum flow requirement.
- Please clean the port and fitting before installation, it will effectively avoid bring dust to the air path.
- Pay attention to direction of air flow and arrow pointing on product body if correct, minding port and thread size if match.
- Pull up the knob of pressure gauge, rotate:
- If you do clockwise rotation, pressure will rise steadily.Pressure will down when you rotate counterclockwise.
- Stop turning after reaching the required index and lock down the knob,forget this step you may face leakage problem.
Oil Adjustment
- Rotate the needle valve in the "+" direction to increase the oil absorption speed, and it will slow down or stop when you rotate to "-" direction.
Refueling
Rotates refueling screw clockwise, oil you add should not exceed 80% of bowl. After refueling, please tighten the refueling screw.
Air Compressor Regulator Precautionary Note：
- Make sure that the pressure gauge is tightly installed on the main body, and pay attention to whether the reading rises and falls smoothly while adjusting pressure.
- When the water level is beyond upper limit, drainage is necessary, otherwise that will cause poor dehumidification.
- Dial Reading: Make sure that the pressure gauge is tightly installed on the main body, and pay attention to whether the reading rises and falls smoothly while adjusting pressure.
Recommended Products
