Your cart is empty.
Your cart is empty. Audio-over-cat goes plug-and-play!
Busy performers can finally ditch the onstage obstacles with this conveniently compact Stage Box.
Designed for easy transport and seamless sound transmission, the system allows you to run multiple XLR lines into a central interface, which then connects to a lighting console, mixer or recorder via a single Cat5 cable. Whether your craft requires many microphones, stage lights, instruments, speakers or other audio gear, the unit’s bi-directional capability, digital/analog compatibility and passive (no power) composition makes setup an absolute breeze.
From live concerts to studio recordings to school assemblies and beyond, this handy kit provides the ultimate in audio and lighting versatility.
Supplies are also built with the highest quality materials for dependable, long-lasting performance at home or on the road.
Keep a system in your music case or lighting equipment, and say goodbye to mixed up lines and messy eyesores. So clean up your act, and add a Coluber Stage Box to your cart today!
QMG
2025-08-22 19:23:10
We have to setup and tear down every week for church and this has worked great for our setup. Out of the rack, through these, and one left, right monitor and sub ðŸ‘ðŸ»ðŸ‘ðŸ»
Readreadread
2025-08-15 10:17:59
Great piece of equipment all techs should have. I bought 2 systems and plan to buy another 2 in the near future. So easy to use. Quiet and best of all so much easier to transport.
Tim J.
2025-08-13 13:27:27
This device is a lifesaver. It was used at an event where I need two large sound systems on a school campus but away from each other paying the same music. I added a 1,000 foot CAT 5e cable and this thing work just as well as my 150-foot old school 16 channel snake. Just imagine trying to run a snake 1,000 feet? One box of CAT 5e cable, two RJ45 connectors, and you are ready.
Stephen V.
2025-08-11 15:13:25
Well built. Works great!
||-||
2025-08-05 12:16:58
Built well, worked fine. There were no wires out of phase like a previous review said (at least on my unit).Not official Neutrik ends but at this price that’s impossible. I may at a later date solder my own on if these start to seem sketchy.Would buy again.
Mark F.
2025-06-20 13:36:51
First time using this technology. The unit is well built, has good solder joints, and the wire used is heavier than some I have seen. The XLR ends are metal and look like they will hold up nicely!
Juan
2025-06-09 17:41:19
I bought 3 of them so I would only need to run 3 cables instead of 11. It’s noisey and IT CAN NOT HANDLE 48v (phantom) power.
Emerson Chen
2025-05-23 10:48:02
Very pleased with these units. I use them with condenser microphones, connected through 100' shielded (needed for phantom power) ethernet cable. The sound quality is excellent. They are also compatible with other Ethercon units.A few things to note: These units do not have pass through. Also, they are a little light -- you may want use gaff tape to keep them in place.
Mariel Rangel
2025-05-17 14:46:56
Mi esposo los compró y al parecer sà le sirvieron
Marco P.
2025-02-03 11:11:15
Excelente producto
Recommended Products
