Your cart is empty.
Your cart is empty. Product Specifications
Size: 38 x 38 x 58 mm/1.49 x 1.49 x 2.28 inches(L x W x H)
Material: Rubber; Color: Grey
Total Weight: 262g
Package Include
4×Rubber Mount with Nuts
TomM
August 21, 2025
Lower the exhaust fan vibration quite a bit - good quality
Robert
August 20, 2025
I used these to bolt down a mini split air conditioner a few months ago. I used locktite on the nuts so they wouldn't back off. They have shrunk down a little bit in the heat, but a little tightening and they're back to snug. I think they'll last for years.
Casey B.
July 16, 2025
The only issue I have with this product, is you get to a certain point of tightening, and even though it isn't quiet tight enough, the screw gives and starts to spin inside the bushing, with no way to hold the other side
bill
June 25, 2025
I don't really know what these are for. It's just allthread with a bumper-looking piece molded to it.Any vibration from an engine would bounce on the bumpers but would loosen the nuts.Only $10 so not worth it to return...I'll use them for something.Just know what you're getting.
Tim Campbell
June 22, 2025
I can barely hear my water pump run. Most vibrate on the floor.
Sprout
June 7, 2025
Decent product!
Customer
April 30, 2025
I was hoping that they would be a vibration Damper. I mounted a generator to my travel trailer with these but they didn't stop the vibration through the trailer. Instead of being two studs molded into the bushing it was a rod clear through the bushing which did very little to stop any vibration.
Timothy Doyle
February 8, 2025
bolts are to short to make it threw the block to put a nut on. not even close
misty
January 14, 2025
I have ordered many sets of these mounts for installing mini splits and they work great ,a must have.
Recommended Products
$25.49
$ 11 .99 $11.99