Your cart is empty.
Your cart is empty.Product Description
jayrad21
2025-08-29 10:37:25
The previous owner had similar turn signals on the back of my 2007 Yamaha Warrior that had broken off. I bought these with the intention of replacing them and the installation was super straightforward. They work flawlessly and are nice and bright, even though they are quite small. I like the look of them and love how much smaller they are than the stock turn signals. I expect them to last the life of the motorcycle.
spartaneli
2025-08-02 17:26:04
Didn't work for the application that I was going for but other than that works perfectly good for any kind of like mini bike or scooter anything smaller
coltswalker
2025-07-29 16:22:24
Hawk 250 Chinese dirt bike, looking to replace broken signal lights. These looked correct but are TINY. I mean, yes a person should take measurements however, no police officer is going to pass these as acceptable. They look like they are for a toy motorbike.
Surfman
2025-07-26 12:33:20
These lights are ok, and work just fine. The price is good. I was hoping for a higher quality than the last set I bought, but they are the same. My complaint? The circuit boards that hold the led's are loose in some of them. No- one else will know, but I'm picky, so it bothers me!
Jessica R.
2025-06-17 17:47:05
These lights are smaller than the original moped light we need to replace, but they are super bright and get the job done. They are some pretty great turn lights. Easy to install and can be done in about 10-15 minutes.
Kyle
2025-03-22 10:24:18
These are inexpensive and look great on sport bikes. Also put a pair on a dual sport
JAMIN C.
2025-03-10 17:56:00
So I buy them because they are inexpensive. The flext sucks, they do not flex. So they are ridged. I have them mounted to a dual sport that I ride pretty rough offroad. If you drop your bike and your turn signals get hit. They will not flex. The rubber/plastic where connects the post that the nut goes around to mount to the bike will 100% pull out and that's the end of the turn signals. Also the plastic cap that covers the led will 100% pop off if you ride rough at all. I went through 4 of them before I decided to put super glue around the edge of the plastic cap after the initial install. That solved that problem. I'll add a picture of the clear plastic cap that you should run super glue around where the cap connectsAlso note. If you tighten the nut, "too much" you're going to pull the whole bracket out of the rubber and they will be done. So getting them tight enough somtimes isn't a thing.But they are inexpensive and I figure the way I ride, I'd rather break a cheap one and replace it, than break an expensive one and replace it.
Gabriel safe and secure
2025-01-28 14:12:50
Nice and bright
JoAnne Sinclair
2024-12-22 17:43:51
One light is not as bright as the other 3 but would still buy again
ROY G.
2024-12-17 13:33:14
LAS LUCES NO SON MUY INTENSAS
Recommended Products