Your cart is empty.
Your cart is empty.Product Description
SURFING SUP SURFBOARD TRACTION PADS
Seafard surfboard traction pads have been proven to be lighter, grippier, and thinner for better board feel and control over standard EVA. Using the finest backing adhesive, keeps your pad stuck to your board, as well as to your feet.
Do you need a traction pad for surfing?
4 Pieces surfboard Traction Mats
Placing surfboard pad along the entire length of your board is not practical.
It is always fun to get new traction pad, it makes it exciting and something to look forward to.
A traction pad is probably, what I think, a important tool to have on your board. It makes your back foot stay in place with the extra grip it offers. It also tells you where your back foot should be placed.
- Marine grade EVA material
- With strong adhesive
- Shock absorption
- Non-skid surfaces
- Heat and UV resistant
- Easy to clean with water
- Easy to install
How To Install A Surfboard’s Deck Traction Pads ？
- Remove any wax from your surfboard. Pour some hot water on the traction pad. That will make the material softer and easy to peel off. It is very important to have a clean board before you apply the front traction pads, otherwise they will not stick properly!
- Take the tape and put a long piece down from tip to tail and center it.
- Without peeling off the adhesive tape on the traction pads, place your tailpad and arch bar down on the board to figure out where you’d like them. The tailpad should be as far back on the skimboard as possible. The arch bar should be about 3-5 inches from the tip of the board depending on your style. Make sure the pads are centered, using the tape you laid down to help you, then outline them with the Pencil (not to worry, the pencil marks will come right off the board).
- Peel off the long piece of tape that you used to center everything. Then take off the adhesive covering on the traction pads and place the pads within the penciled outlines. Make sure to press down on these pads hard to get them really stuck on there.
- Recommend letting the grip dry for 24 hours before taking your board for a surf. To allow the glue enough time to harden. This will ensure they don’t come off.
What do you want to know about our surfboard pad?
- Q: Is it your material UV resistant, and salt water proof?
- A: Yes, our EVA foam material is marine grade, so it is UV resistant and salt waterproof.
- Q: Is the adhesive you offer permanent?
- A: None of the adhesive in this world is permanent. But our products has powerful adhesive for max. stick to the board.
Customer
2025-08-25 18:20:15
Non slip footing
Troy Brinker
2025-07-28 13:56:35
not very sticky
Xavier
2025-04-14 10:45:23
Used to line the edge of my polypropylene sun roof on my tractor. opted to glue it on and added electrical clamps to keep it in plce. It is surviving the tree limb and brush battering quite well.
Clayton Fisher
2025-03-17 19:56:28
Put this on my one wheel and I’m in love even put it over the grip tape and it sticks very well
Rigel
2025-03-02 13:41:10
Good looking and great performance
Oscar a Gomez
2025-02-28 12:48:32
I purchased a brand new surfboard and didn't want to wax it all up so i purchased these pads. During the second session out in the pacific and the surf was about overhead high, one by one they peeled off. Terrible!
jawbox
2025-01-24 16:25:03
As other reviews have indicated, these dont really stick to the board. Had to apply extra glue to keep them on.
Recommended Products