Your cart is empty.
Your cart is empty.Product Description
Wishiot GY-521 MPU-6050 MPU6050 Acceleration Sensor
The InvenSense MPU-6050 sensor contains a MEMS accelerometer and a MEMS gyro in a single chip. It is very accurate, as it contains 16-bits analog to digital conversion hardware for each channel. Therefor it captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino
Note：See product documentation for how to use with the Arduino IDE
Parameters
Use the chip: MPU-6050
Power supply: 3V-5V
Communication modes: standard IIC communication protocol
Chip built-in 16 bit AD converter, 16 bits of data output
Gyroscope range: + 250 500 1000 2000 ° / s
Acceleration range: ± 2 ± 4 ± 8 ± 16 g
Pin Definition: VCC, GND, SCL, SDA, XDA, XCL, ADO, INT
Pitch:2.54mm
Board size : 20mm(length)*16mm(width)
Jay
2025-08-24 11:39:56
The IMU works great with my Teensy4.1 board on a custom drone but use caution when choosing fasteners. I broke capacitor c11 while tightening the board with an M3 screw. My picture shows a flat head Philips M3 screw for reference.
Jason.D
2025-07-27 19:08:51
The accelerometer and the gyroscope works fine, but the temperature sensor is not that accurate. since it is a bonus feature it is still a good price.
TimBit
2025-03-03 16:15:10
It's not what I wanted to buy, but with the chip prices, I had not choice. They do work for what I needed. Thanks, came in on time.
Ridsh Rimski Casimir
2025-02-10 16:09:38
One of the 5 was not working out of the box
Recommended Products