Shopping Cart

Your cart is empty.

Your cart is empty.

6760, 10 Series, Single Short Unibearing

4.4 (3) Write Review
Free shipping on orders over $29.99

$20.61

$ 8 .99 $8.99

In Stock
  • T-slotted aluminum unibearing made for the 10 series.
  • Measures .312" tall/thick x 2.063" wide x 1.875" long.
  • Typically, this rides on the 1" side of a 10 Series extrusion while afixed to another 10 Series extrusion.
  • Inlcudes pads, screws, and shims.
  • Pads are made out of self-lubricating UHMW material.


The single short UniBearing has an open design that enables customized layouts. It is an option that is commonly used in applications with one guiderail. The UniBearing is easy to quickly install or remove without taking it apart, allowing reduced retooling and downtime and increased productivity and flexibility. The pads are mounted using stainless steel flathead socket cap screws that secure it to the housing and eliminate the need for high-cycle pads. The bearing can move or be fixed; when fixed, it allows the guardrail and assembly to move. All UniBearings come with pre-drilled brake holes and tapped mounting holes that enable attachment of accessories to a flat surface.


Jeff
2025-07-20 16:18:32
Bought these for use for a robotics project as part of the FIRST Tech Challenge.They work well, but were a little big for out project, so we cut them in half and they've held up fine, even after doing that.
RST
2025-06-14 14:48:36
Our FTC robotics team uses these for a lift. We cut them in half to save money and increase the lift span a bit. They fit the 10 series extrusions well so that they don't tend to bind.
Very Rural Customer
2025-04-08 11:16:49
works very well, just wish it was less expensive