Your cart is empty.
Your cart is empty.Product Description
Replace OEM Part Number: 676061 214-1001 1101428 379147 LCI 366043 369506
High torque, not easy to burn out
Large shaft, not easy to wear out
A. Sellers
2025-08-31 12:41:17
Exact replace for my failed RV step motor. Easy 15 minute replacement. Step again works perfectly!
Susan
2025-08-29 17:04:05
Went in quickly. Works very smoothly
Dakota Dave
2025-08-14 13:47:24
This was an exact replacement and worked perfectly after a simple remove and replace. I've only used it for 2 weeks so longevity is unknown at this point. But happy so far.
Calie
2025-05-28 18:24:32
We purchased this step motor for our RV, worked good for a few months then began not retracting intermediately. I contacted the seller and he was so understanding and offered a full refund or a replacement at no charge. Great customer service and quick response. I would highly recommend this excellent seller for any purchase in the future.
tcaruso47
2025-04-10 19:07:59
Easy to install works as should
Mark
2025-03-25 10:33:26
Very smooth and quiet. Needs washer on shaft for proper drive gear fit to gear head.
Marty
2025-03-17 15:17:37
We ordered, we replaced, we were happy........till we were on a trip just over 3 months from purchase and its broke just like the first one same noice same issue. Also remember we are a part time RV issuer so the step motor was only used many a dozen times. Waste of money and time. Really would have liked the moror to have worked used in a Fleetwood Discovery 2019 LXE 44B.
keith
2025-02-12 11:20:40
The motor was the correct unit and was a perfect match-It has only 3 bolts showing on the outside and one plug, simple right? I checked and the plug was an exact fit so looked pretty straight forward- but no installation instructions and 3 new mounting bolts but no nuts or washer made it difficult to install. - the old unit had 3 bolts going the plate, but 3 nuts were mounted on the other side of the mounting plate. in order to reach the 3 nuts, you had to drop the plate the motor is mounted to. And in order to drop the plate you must disconnect the actuator arm. Once you get the WHOLE unit out now you have to move the gear from the old unit over to the new unit (you'll need a snap ring plier) After that just reinstall the plate assembly and plug it in-- works great but took most of the day to learn as you go???? be sure to get the gear in the same position as it was in so it opens and closes correctly.
Recommended Products