Your cart is empty.
Your cart is empty.Product Description
Jose Antonio Vazquez Serrano
2025-09-05 13:45:38
Excelente
tess montez
2025-07-31 12:09:19
I didn’t have a single bad sensor in the whole package and they work great. You can find drivers for them online if you just google the name. I’m a noob when it comes to programming but I had these set up fast with clear/consistent data in no time. I’m in high altitude and the pressure readings were all within spec. Thanks!!
Steve
2025-06-22 11:05:04
I bought these to hook up to an ESP-8266 as a data logger. Hookup was simple and once I uncrossed my wires (oops) it worked perfect.I'm actually only using the pressure part of the sensor. I have it mounted inside of a vacuum chamber to record the vacuum pressure. So far it seems fine down to about 20 In Hg. That's as far as my pump goes.Though I don't use it, the temp appears to be responding correctly as well. I haven't really paid attention to the altitude at all.They work fine with the Adafruit_BMP085 driver.Quite happy with these low cost little sensors.
Steve
2025-05-21 18:48:08
could not get the readings to be a real world value. typical temperature with all arduino sketches tried was 220 degrees celcius, had some luck with altitude after hours of manipulation.
Customer in BC
2025-05-08 11:54:26
90 degree mm pins would be more practical. Worked well for a pressure differential application.
Jose Antonio Vazquez Serrano
2025-04-27 18:46:05
Excelente
tess montez
2025-03-31 16:12:10
I didn’t have a single bad sensor in the whole package and they work great. You can find drivers for them online if you just google the name. I’m a noob when it comes to programming but I had these set up fast with clear/consistent data in no time. I’m in high altitude and the pressure readings were all within spec. Thanks!!
Steve
2025-03-29 11:09:46
I bought these to hook up to an ESP-8266 as a data logger. Hookup was simple and once I uncrossed my wires (oops) it worked perfect.I'm actually only using the pressure part of the sensor. I have it mounted inside of a vacuum chamber to record the vacuum pressure. So far it seems fine down to about 20 In Hg. That's as far as my pump goes.Though I don't use it, the temp appears to be responding correctly as well. I haven't really paid attention to the altitude at all.They work fine with the Adafruit_BMP085 driver.Quite happy with these low cost little sensors.
Steve
2025-03-06 10:25:31
could not get the readings to be a real world value. typical temperature with all arduino sketches tried was 220 degrees celcius, had some luck with altitude after hours of manipulation.
Customer in BC
2024-11-21 18:33:29
90 degree mm pins would be more practical. Worked well for a pressure differential application.
Recommended Products