Your cart is empty.
Your cart is empty. 70" Transmission cooler lines kit with AN6 adapter fitting for transmission TH350 TH400 4L60E 4L80E 700R4 200-4R TR6060 AOD C5
Package List: 2 x 70 inch & 3/8" inside diameter stainless steel braided hose
4 x 90 degree 6AN female to 6AN male adapter fitting
4 x 6AN to 1/4NPT adapter fitting
2 x 6AN to 3/8NPT adapter fitting
2 x 6AN to 1/4NPS adapter fitting
4L60E Application:
Compatible with 94-96 Roadmaster Fleetwood
Compatible with 04-07 Rainier
Compatible with Silverado 1500-2500 (2500 with 6 bolt axle pattern)
Compatible with 93-05 Astro 94-02 Camaro 04-12 Colorado Canyon 03-12 Express
Compatible with 02-08 Avalanche 94-05 S-10 Blazer 93-09 Suburban 1500
Compatible with S-10 SSR Tahoe Sierra 1500-2500 (2500 with 6 bolt axle pattern)
Compatible with Yukon
4L80E Application:
Compatible with 91-13 C/K Silverado Sierra 2500 3500 Suburban Yukon
Compatible with 91-09 Express Savana
Compatible with 91-92 Eight
Compatible with 91-97 Turbo R
Compatible with 99-06 Arnage Red Label / Bentley Arnage R/RL/T
TR6060 Application:
Compatible with 07-07 Mustang Shelby GT500
Compatible with 08-13 Corvette
Compatible with 08-17 Viper
Compatible with 08-16 Falcon
Compatible with 09-on Challenger
Martin
2025-08-28 16:37:57
We replaced the hardline with these flexible metal lines in a 1984 gmc square body. The lines looked great with their metal outside, and installing them was easy. They cool the transmission fluid and function as expected. Great fit, easy to run, easy to tie down and truck is up and running
Tenatra
2025-07-18 14:42:58
I used this Transmission Cooler Lines Kit on my AOD transmission. Overall, it works, but I did run into a couple of issues. I needed to purchase two 6AN male flare to 1/8 NPT pipe adapters for the radiator side, as my cheap aftermarket radiator required them. Your results may vary based on your setup.To clear the transmission, I also had to use both elbows provided along with the AOD adapters on the transmission side. It was a very tight fit, but it ultimately worked out.If you're prepared for some adjustments, this kit can get the job done!
Craig
2025-06-18 12:37:13
Made well
Nicolas S Kitchen
2025-05-25 17:50:15
Worked perfectly for my 4r70w 96 F150.
Jeremy
2025-05-06 13:14:26
The media could not be loaded.
Ramie Massie
2025-03-21 17:59:47
When I received the Braided Transmission Cooler lines, one of them had a kink in it. I installed them anyway. after about a dozen start-ups for testing, the kinked one started leaking. These lines are installed on a frame off restoration rolling chassis project, that is still on the vehicle lift. I am glad I wasn't driving it or I probably would have burnt my transmission up from loss of fluid. I am So disappointed in such an expensive Product that failed so miserably. Don't buy this Junk!
Nathen Bennett
2025-01-22 11:02:38
Put them on a custom hot rod good 200 miles on them no issue and look great not restricting
bruce farley
2025-01-08 14:44:01
I've tried over and over to stop leak on 1 line. Still leaking maybe the compression fitting. Dont want to return product because 1 line is fine and don't want to disturb it. Dont want to climb under truck to pull 1 line rather do it all at once im 76 yrs old
Recommended Products
