Your cart is empty.
Your cart is empty. Power: DC 6V~9V
Current: 2A @6V
Rate: 7L per min or 110GPH (max @ 12v). 4.5L/M or 65GPH @6V
Intake/Outlet: 8.6mm ID and 12mm OD
Cut off: 1.5M (5ft) or 2.16psi
Self prime: No.
Water feed: Prime or by gravity
Motor type: Brush
Submersible: No
Overall size: 30mm x 78.3mm
Note: Do not use 12V for over 15 minutes, it'll get very hot!
Warning: Do not let it run dry without water. Use gravity to feed water inline.
Jim Halford
2025-09-03 17:26:55
The price is right and the shipping was great as well. The only thing I have about this pump is what is the proper voltage do you need to run this pump? If they put a little information about this pump it too would get an a grade however I must give it a B for now.
Tim
2025-08-16 12:08:50
Ran for two hours. The bearings are screaming. The case is at 250+ degrees and melting. It's actually raising the temperature in the system I'm trying to cool.
Mike D.
2025-08-01 20:16:57
i use this for cpu cooling and thought it was awesome, till i went through 2 of them in about 6 months. they work fine in short bursts or if you had a way to cool em. it is also possible my amperage wasnt right, which wouldnt surprise me. i do have to say, if i were building a fountain or something along those lines, i would buy it in a heart beat, but for cpu cooling, not the best option.
Adam Laceky
2025-06-23 10:19:02
I bought this pump for one purpose: to simulate a person urinating as an April Fool's prank. See, where I work, the men's room has only one stall. Every day I go to use it, and someone is in there. Every guy I work with wishes there were just one more hole in that pot. So, to make my work environment even more frustrating, I bought this pump. I hooked it up to a 6-volt lantern battery, 18 inches of tubing and other minor accessories, and placed it in the toilet stall on April Fool's day. I also set up an old pair of shoes and pants sleeves to complete the illusion that someone was in there taking the world's longest whiz. It ran for more than 3 hours before someone finally figured out that no one could possibly be in there for that long. It successfully recycled the water far longer than I had any hope it would need to--I thought the joke would be over in about 45 minutes. Yet, to my sublime satisfaction, I got to watch Larry from accounting stand outside the john, watching the time, and wondering how much longer that guy would be in there. Priceless.
ThAzn1der
2025-05-28 18:48:48
Bought and used it once to try to make a canister filter but not being submersible made it a bit more difficult since it isn't self-priming either. so i guess i'll just have it sitting around until i find a better application for this product but it was cheap so i can't complain.
mromrell
2025-02-23 14:51:06
This Pump broke after less than 3 hours of running. I wired it up to 9v DC 200mA power (Which should work fine for this pump). and now its busted. That said, when it was running, it ran quietly and ran well. but it didn't last long
Vince
2025-02-06 13:55:59
Using this for my boat and freash water washing of hands ect. I put it in a 5 gallon bucket. It only takes 2 min 15 seconds to empty the whole buckets. I am buying a nozzel for the end to slow the water flow some. The little pump kicks butt, doesn't self prime so you will need pressure behind it or put it in water and stand back. Great deal.
steam
2025-01-30 17:09:08
After I bought this little pump I found out that its performance is excellent and I am thinking to build an artificial miniature river on my model train layout, I am sure this pump is going to do a very good job.
Recommended Products
