Your cart is empty.
Your cart is empty.Warmly Reminder:1. Please choose the right current circuit breaker base on your requirements.2.Please assure the products work on right working temperature to avoid too heat then stop work..Features:No need to keep replacing fuses anymore, simply reset breaker and you are ready to go.Easy to operate with manual reset arm.good conductivity, high temperature resistance.Splash and dust proof Water proofUnique Push Button Reset can also be used as a Kill SwitchSpecification:1. (LxWxH) 74 x 49 x 44 mm /2.9 x 1.9 x1.7 inch2. Net weight: 0.2 LB3. Voltage: 12-48V DC4.Rated current: 30/40/50/60/70/80/100/120/150/200/250/300 Amp5.Storage Temperature: -34 °C to 149 °C (-30°F to 300°F )6. Operating temp: -32°C to 82°C (-25°F to 180°F).7. Material: Plastic and MetalPackage included: 1x 80A Waterproof Circuit Breaker2 x 6AWG-1/4'' Wire Lugs4 x M6 Copper Washers
IceQx13
2025-08-27 14:18:48
This works very well, just as to be expected, with the correct power. It didn't take too long to install; it comes with clear instructions. It is small and compact, which is a plus, but I can still get my fingers in there. As to being waterproof.. it actually is!
D Spratt
2025-08-20 19:01:43
looks good
Customer
2025-07-11 10:09:23
Replaced fuse holder. , terminals are to small for 300 amp wiring
George Harbin
2025-07-10 11:50:04
Perfect amperage for my small stereo install.
Thomas Burns
2025-06-17 10:00:39
Bought two of these for for pieces of equipment with direct draw from larger batteries. Works very well no issues. Also easy to mount almost anywhere.
Mark Burton
2025-01-31 13:46:59
This breaker works well. It does trip a little below its rated value at 247 amps when tested to a resistive load. However, that does not bother me as it is close to the rated 250 amps. It also works well as a means of disconnecting with the press of a button. The build quality is okay and is holding up well in everyday use with no nuisance trips. I would buy it again.
Johnny WEBSTER
2024-12-11 15:09:10
Easy to install, fits the need.
Sandy Nieto
2024-12-06 14:57:42
Meant to be used with smaller cables, not 1/0 ones.
Recommended Products
