Your cart is empty.
Your cart is empty.Product Description
Product Applications ：
96452A4 96452A1 Trigger For Mercury Outboard 134-6452 96452A2 96452A5 30 JET 40 45 50 75 80 HP 73372A1 73410A1 76681A1 77000A2 2 Stroke Carb 4 Cylinder 30HP 40HP 45HP 50HP 75HP 80HP
Josh
September 4, 2025
My boat mechanic installed this trigger and it was miswired. We tried to use different combinations with no luck. In the end we bought a different one and the boat now runs.
TW
August 23, 2025
I bought this to replace a working trigger on my 70 horse 1980 mercury outboard. The old trigger was still working, just wanted to put a new one on there. When I try to start it with the new one, it was spit in sputter, stop the starter, but would not run. Long story short I put the old trigger back on and it runs fine. I wonder if the wires got flipped around inside the trigger because I made sure that the right colors went to the right terminals on the CDI box.
michael sones
August 11, 2025
The trigger wires were not bundled together correctly. 3 wires should be bundled with a yellow sleeve and the other 3 wires should be bundled with a black sleeve to correspond with the yellow bundled wires from the stator. The wires on this trigger were bundled in pairs with all yellow sleeves which makes installation and firing order trial and error.
James
July 26, 2025
I have a 1988 mercury 60hp that was running but the original trigger had a broken adjuster.I put the new one on and could not adjust enough to even come close to having timing set.Closest I could get was still 30 degrees off.And motor would no longer start or run.Put the old one back on just to check ,set the timing and motor started right up .I am sending back for a refund and have already bought a mercury trigger.I would not risk damaging my motor buying or trying another one of these.
victor ditola
June 27, 2025
Put it on my motor for the third time different ones And it ran less than a minute and went out again at least I didn’t have to get towed back this time I never left my yard before it went out
Bob
May 26, 2025
I had to reinstall the original because the new one was defective.
Carlos
May 5, 2025
did not fit 1994 mercury 25hp seapro. gives only 0,5volt signal. this outboard requires 5 volt
Juan F.
March 15, 2025
I didn’t last two months
Customer
February 18, 2025
I have spark with my old trigger but the insulation on the wires were deteriorating so I purchased this unit & installed it now I have no spark even after reading other comments saying don’t buy well now I’m saying it don’t buy
Jeff Leal
January 4, 2025
This part was exactly the same as the OEM part that it replaced.
Recommended Products