Your cart is empty.
Your cart is empty.Product Description
A SERIES Transmitter + Receiver
Product parameter
- Protection level ：IP66
- Frequency :433(MHZ)
- Temperature:-35~+80℃
- Control distance ：100M
- Transmitter Power :2* AAA Batteries
- Transmitter Weight:200g
- Transmitter Dimensions:11.5x7.5x5.5cm
2/4/6 Channel Remote Control
- Antenna built-in,360 degree barrier-free remote control;
- Strong penetration, no need to aim;
A series Industrial Wireless Remote Control
Transmitter + Receiver
- Direct assistance;
- Super stable signal;
- Quality circuit board;
- 20 millions buttons ;
- IP66 class dust-proof and waterproof.
- 0.01S Quick response,
Noted:
The remote control needs to be used with the contactor. It cannot be directly connected to a power source. Connecting the power directly will burn the motherboard.
A Series Remote Control : Safer, More Efficient, Durable and Convenient
High quality circuit board
- 360 degree barrier-free remote control;
- Strong penetration, no need to aim;
Unbreakable case
- Glass fiber reinforced nylon case;
- Unique non-slip and ergonomic design;
- IP65 class dust-proof and waterproof.
Can be used in multiple industrial fields
Software
Simple button functions can be changed through the system (a dedicated USB cable needs to be purchased separately)
Silicone push button
More durable silicone buttons for you to press more 2 million times.
Packing
The product is packed in carton with foam cushioning material to prevent collision during transportation.
omar
2025-08-09 11:34:15
Easy to use
Q. Smith
2025-07-27 12:09:13
Six relays on the mother board and only three used. When you push the Start button on the remote it immediately activates the pump, which leaves the pump running unit you push Stop. This is very hard on the pump when neither the Up or Down buttons being pushed leading to premature pump failure.The Start button on the remote should activate the motherboard, the Up and Down buttons each need a relay and an additional relay to provide pump activation only when the Up or button is pushed.Unfortunately they have programmed the pump relay for the pump to be activated immediately and continuously with the Start button.
B. Katz
2025-05-24 17:56:51
nice unit for my shop's gantry crane. nice not having a tethered cable. quality construction, easy to install.
dwzkd
2025-02-10 16:46:08
Instructions are lacking. We tried everything to get it to work. It may have been defective product? We could get the remote to flash the LED's but that is about it.
Recommended Products
$19.99
$ 7 .99 $7.99