Your cart is empty.
Your cart is empty.ACDelco GM Original Equipment Multi-Purpose Temperature Sensors are GM-recommended replacements for your vehicle’s original components. It senses the temperature of various liquids for a variety of components including radiator cooling fans, temperature gauges, and warning indicators. Typically, the temperature sensor sends a signal to the control module and the control module then controls the on/off function of another component. These original equipment multi-purpose temperature sensors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Luis Alberto Ramirez
2025-08-12 18:28:02
fix with my truck
Fafafohi
2025-07-23 11:27:50
Oem doesn’t get any better
Jose navarro
2025-06-10 18:41:42
De fabrica
Jim
2025-04-26 18:25:11
This sensor is one of the few you can easily replaced in your vehicle. It is good quality and most importantly is AC Delco. Great quality and price.
Don Currence
2025-04-19 21:31:50
This works. I Ordered this 9/3/23 was $13.72 now $18.72 {10-26-24} and says will not work. It works. Check the MAP sensor OTUAYAUTO Map Manifold Absolute Pressure Sensor - Replacement for 1985-2004 OEM# 12569240. Check your O2 sensor replacement it is cheap.May to fix this hose or rotten --APDTY 707211 Engine Air Intake Throttle Body Hose. This will work.
Az-Chris-82
2025-04-11 18:30:04
Customers happy works as advertised
Another Block
2025-03-23 16:15:37
Shorter then the OEM but easy to install and seems to work fine
thomasterrible
2025-03-22 12:34:18
This is the Intake Air Temperature Sensor that is post air filter/pre-throttle body. It measures the temperature of the incoming air to help the computer to adjust the air fuel mix. Over time these can become dirty and less effective or damaged. Cleaning these can help though solvents should not be used. If replacement is needed at least the cost is low and can be done in about two minutes by yourself. These are very easy to install since you just unplug them and pull them out of a rubber grommet and insert them back in. The plastic material is not strong and will break apart easily if you use metal tools with this sensor pretty easily. To avoid damage, especially to the circular part of the plastic that mounts flush on either a new sensor or if checking a sensor you are not going to throw away.Very simple installation. Unplug, remove old sensor, insert new sensor in to lubricated grommet and plug back in.I have been finding some good priced on OEM GM parts lately on Amazon such as a TPS (Throttle Position Sensor) and IAC (Idle Air Control Valve) both of which even those not mechanically inclined can install themselves easily with a torx bit screwdriver. I am now checking Amazon for other OEM GM replacement parts.
Dyllon
2025-03-09 18:02:14
Works with Holley terminator X. Get a gm pcv valve grommet from Dorman and it fits
Steven Kim
2025-03-06 10:19:21
Works perfectly on 2004 GMC Envoy XL 4.2L L6 . ACDelco is best. So far so good for three months. It is running 4.000 miles. Working good. I highly recommend it to everyone. Thanks Amazon always
Patrick Wessels
2025-02-21 12:04:08
Good OEM replacement part. Buy it :)
Benny
2025-02-08 14:38:56
As promised, arived early, couldn't even find this sensor in town. Thanks!
Paul Busuioc
2025-01-16 15:17:46
Easy to replace
Recommended Products
$45.43
$ 20 .99 $20.99