Your cart is empty.
Your cart is empty. Specification
Product Name: Microwave turntable coupler
Material: PPS plastic
Shaft Length 0.63 inch / 16mm
Shaft OD 0.43" / 11mm
D Port Size 0.19" / 5mm
Package Details:
1 × Microwave Turntable Y-Shaped Bracket
James Cole
2025-08-01 16:47:05
Product great. Fit well. Description was valid
Tommy_J
2025-07-17 16:13:42
This item fit my microwave/convection oven perfectly, but ended up melting when using it. It's evidently only to be used in microwave ovens.
Bobby
2025-07-10 13:28:38
The microwave in our camper needed the coupler for the turntable when we bought it so I had nothing to measure to see what to buy. After trying to find one for a B&D I just took a chance on this one and it fits and is working as it should
neensw
2025-05-22 18:24:23
Tried to melt glue stick in microwave and the cup melted this piece melted (still n hole) and the bottom of glass tray melted and burned n that spot
221B7437
2025-04-02 14:55:04
It worked alright for about a month, and then I noticed the turntable wasn't spinning consistently and realized it had melted.
Poppy Bennett
2025-03-13 11:15:38
Bought this for a replacement for an old microwave, and it fit perfectly!
Olivia M. Olson
2025-02-25 14:21:49
I was so worried this would not fit because it looked different than my current piece that needed replacement. However I measured closely and took a chance. It’s been working great so far!
Jim and Mary Ann Boyd
2024-12-28 12:09:29
I think the measurements were off and it is smaller than what it days. Could be I got a defective one. For the cheeped to uuccupriced Husband will see if he can file the inside since it’s too small
Recommended Products
