Your cart is empty.
Your cart is empty.Fan Spacer, 0.5 in Thick, Bushing / Hardware Included, Aluminum, Black Anodized, compatible with Chevy V8 / Ford V8, Each
Ri
2025-08-11 14:04:38
Fits with old Chevy C10 . Very easy installation
Eric Torres
2025-07-15 16:28:39
Did not fit the application we had on our truck but it is not the device's fault as it is specifically made for a different type of fan clutch assembly than the one we have. However, it is very good quality and well made.
Justin Grogan
2025-06-10 15:27:34
This spacer will not fit GM water pump flange. Looks very well built wish they made it to fit a 2"bolt circle or would have mentioned it in the specs
Chris
2025-05-23 17:09:20
Work good put my fan where it needs to be
Lara Anderson
2025-05-13 16:54:01
Good spacer unusable hex head bolts if using a clutch fan.
jared kilts
2025-03-23 18:34:16
Perfect fit.
DPG70
2025-02-27 12:03:01
This spacer was a little pricey but it is high quality and looks great as well. If you pay attention to detail pay a little more for this spacer.
Winkzilla
2025-02-19 09:19:33
First it comes with Allen bolts. It is right there in the picture and in the description. It is something Allstar Performance does not hide.However, be advised that if you are using the spacer with a fan clutch, the Allen bolts are probably not usable, certainly in my application they were not, as there was no room between the spacer and clutch for an Allen wretch to fit in. You will have to purchase Hex bolts to replace these. Or, perhaps you could grind down an Allen wretch small enough to fit in the tight space, but only if you are lucky enough to be able to hand tighten the bolts in first.For the life of me, I do not understand why they supply Allen head bolts. Perhaps there is something I am not seeing here, but it just seems stupid, especially at the price you pay for it. I would rather not be required to purchase bolts I cannot use, reduce the price, and let me get the right bolts for my application. FYI, the Fan Clutch I used was a Hayden 2710.Since I was not the most knowledgeable person on bolts before this, and not seeing this problem until in my hands, I lost a lot of time learning about bolts (As no information was given as to the size, thread and grade of the bolts supplied) and running to 5 different Automotive stores before be able to find four bolts from two different stores to replace these (Last set of two at each store). Apparently my vintage car ran some old American sizes that Automotive stores don't seem to carry much of anymore, and specifically in 2 inch.Outside of that, the spacer seems find, and I liked the solid (not split) 5/8 to 3/4 adapter. The tolerances seems very good.
Al M.
2025-02-06 13:41:06
Worked like a charm. Fit nicely on my sbc 350cid. It puts the fan further in the shroud for better cooling.
Theriault Dany
2025-01-01 12:18:27
Pour mon stock car afin que mon ventilateur soit plus pret du radiateur !
Kerry
2024-11-23 18:04:59
Like the product overall. Fine thread doesn't work for my water pump on the cap screws.
peteboy
2024-11-12 14:44:35
THE BOLT PATTERN OF THE SPACER IS TO SMALL TO FIT SBC ON THE WATER PUMP SHAFT
Recommended Products
