Your cart is empty.
Your cart is empty.Allstar Performance dipsticks feature a positive lock to keep dipstick in place and seal tight to prevent fluid leaks while sealing out moisture and debris. Steel case fill tubes have a gold finish, include a welded-on mounting tab and are fitted with a rubber grommet type seal which reduces the risk of leaks common with traditional o-ring seals. Locking dipstick tubes are required on 10. 99 and faster drag cars.
J.W.
2025-08-28 17:18:17
Fit well, tweaked it a bit to fit the exhaust I had run. Good product!
Joe Beech
2025-08-27 15:26:44
I installed this C6 dipstick on a 69 mustang. The factory tube bolted to the second bolt up from the bottom. This one bolts to the third one up. this bring the tube about 2" closer to center of the firewall. the relocation helps get the dipstick out from under the export brace a bit more.
Don
2025-08-19 17:37:25
Fit great on my 351W With 4R70W Trans and uses a thick rubber seal.
Tom E
2025-07-03 18:41:10
works fine
Miller
2025-06-15 11:12:38
Great fit, sealed well, easy to install on my 1989 AOD transmission.
Flying dutchman
2025-06-10 15:50:39
Very nice product
Chuy
2025-05-12 20:29:41
I like it because uses a boot seal not a o,ring
Jim L.
2025-03-13 16:56:03
Good fit and easy to install.
bob card
2025-02-08 12:55:18
everything went as seller had listed, very pleased
foxbody
2025-01-29 13:16:53
on my mustang l had to do a very small bend to have it fit just right but everyone may not have this problem. very nice fit with the hat for the trans tube, would buy again !
Recommended Products
$113.95
$ 55 .99 $55.99