Your cart is empty.
Your cart is empty.Product Description
CDude
2025-09-01 10:09:55
Many LED bulbs have a very bluish-white color to the light. These give off a very warm light similar to incandescent.
Coupeowner
2025-08-06 10:56:14
A huge light upgrade for the map lights and courtesy lights in my 2009 Sprinter. Definitely worth the upgrade.
Christian
2025-07-06 13:19:51
I just installed these and I am very happy with them! I can't speak to their longevity because I've had them in for about 10 minutes, but I'm very pleased with everything else.I needed a bulb that matched my three requirements: color temperature (3000K), very bright, and most importantly needed to work with car's electronics. I actually tried several other bulbs before, but I could never get a bulb that worked within my requirements. I don't understand how it works, but some bulbs messed with my car's key fob. Maybe it was some signal interference, but I don't know. I heard that some cars require CAN bus bulbs (controller area network bus).I don't know if these are CAN bus bulbs, but they work in a system that requires them. Plus these bulbs were actually the right color temperature, not that super white color that everyone sells. And they are super bright!
Quality Quester
2025-06-25 11:57:24
These have brightened my car. The original #192 incandescent lamps had left the map lights dim and directional: useful, but requiring special positioning of documents "where the light was" for good viewing. These LED lamps provide both brightness and spread (flood), rendering everything in my car's forward cabin well lit. Just one of these outperforms even the car's dome light, and two of these simply put the dome light TO SHAME.The color is simply white: neither the tan of "soft white" nor the sometimes blue of "cool white" or "daylight". That suits me well, as I dislike either extreme.These are dimmable, though they behave a bit differently than incandescents. These get rather dim by about 9 V and drop out at about 7.5 V. A #192 incandescent, on the other had, still shines somewhat at 7.5 V. In my car, the difference seems minor to moderate: these dim noticeably and then extinguish from a somewhat brighter level than the incandescents.Conveniently, the "nonpolarized" claim is true. Plug the LED lamp in any way you like. If it fits and you've got a 12 V electrical system, it works.Some hints are required.CAUTION: Do NOT use these for side marker, license plate, nor similar exterior lighting unless you can determine the result is similar to your vehicle's original incandescent lamps. Why not? Federal motor vehicle regulations. U.S. Code of Federal Regulations (CFR) Title 49 ss571.108 (overly intricately Title 49, Subtitle B, Chapter V, Part 571, Subpart B, ss571.108) specifies lighting intensities, to promote safety. Sure, you likely won't get a ticket, but go ahead and do the right thing.While these have a T-1+3/4 (OK, T10 metric) wedge base, they exceed the overall size of T-1+3/4 lamp and so simply will not fit in some applications. So, check for space. The body reaches 15/32" wide (about 12 mm) and the total length is 1+3/32" (about 28 mm) with a "bulb portion" length of 0.8" (about 20.5 mm).Contact issues may prove easily resolvable. Just bend each wire so it runs diagonally from right next to the center ridge out to the edge of the base. That's it! One of my car's map light "sockets" (not: just pairs of folded sheet metal contraptions with each pair intended to somehow have its contacts remain parallel) gave contact trouble even with the original incandescent lamp (cured by depriving the "socket" of power and judiciously applying needle-nose pliers). Both "sockets" eventually gave contact trouble with these LED lamps, _until_ I reshaped the LED lamps' contact wires as described above. Presto! Reliable contact and uninterrupted luminous convenience.
Jim
2025-06-13 12:42:56
These use a higher quality LED than other cheap options. I bought a couple of different types to test out and these were the brightest even though they used less LEDs. Color temperature is good as well, definitely a soft white, it was about the same color as the incandescent it replaced. In the pictures one shot shows this LED vs a cheaper and larger LED and the other shows this LED vs the incandescent. The dimmest was the incandescent, then cheap LED and the Alopee LED was the brightest. Test was done with map lights of a Rav4.
garrowood
2025-06-10 17:36:47
These are in a warm LED color that mimics the old standard incandescent bulbs and not the cold screaming bright LED color
Dan
2025-05-24 10:56:37
These lights were the perfect color and hue. Sadly, they kept blinking on and off after installing them. Really annoying. Hopefully they fix the problem.
superdeeduper
2025-05-12 15:38:10
brightness and light quality are good but i broke 2 of 4 just trying to get them in and out of the socket and into the lens fixture. it's a tight fit into the fixture because the bulb end is so much bigger than a standard 194 bulb. i also had to add solder to the connection wires on the bulbs because the part that plugs into the socket is thinner and has only 1 thin contact wire whereas the old 194's had a looped wire effectively giving you double the contact area.
Buyer
2025-03-25 11:06:33
Warm white colour temperature equivalent to incandescent
Mark
2025-02-24 10:02:36
Gaven een mooie warm witte lichtopbrengst alleen trilt het licht beeld van de leds.Teruggestuurd wegens hinderlijke licht opbrengst
Andoni Ripoll
2025-02-23 17:49:45
Cuando se ponen estas bombillas en un coche hay que poner una adaptación al circuito para que no haga cosas tÃpicas de leds. Como la bombilla no lleva esta adaptación y yo no la he puesto, lo que sucede es que cuando apagas la luz sigue iluminando un poco. De vez en cuando parpadea también al estar encendida
Fee W
2025-02-22 14:39:47
Used to replace filament bulbs in my American 5th wheel caravan. All bulbs worked perfectly and put out more light than previous bulbs all whilst using minimal power.
Bob
2025-02-13 13:19:22
J'avais précédemment une LED trop froide pour mon plafonnier de 206cc. Ces LED plus chaudes sont beaucoup plus agréables, pour moi c'est pile la bonne température de blanc. La luminosité est légèrement plus faible que ma LED précédente, mais finalement bien suffisante et plus douce pour les yeux lorsqu'il fait nuit. Le tarif n'est pas le plus faible, mais la plus value du produit est le "form factor", c'est à dire que c'est exactement le même format qu'une ampoule à filament classique, ce qui assure la compatibilité parfaite.
Recommended Products