Your cart is empty.
Your cart is empty.Product Description
Compatible with Honda Models:
- 1998-2002 Accord L4 2.3L SOHC Automatic Transmission
Front Motor Mount
Part Number:
A6572, EM8801
Rear Motor Mount
Part Number:
A6564, EM8845
Front Left Motor Mount
Part Number:
A6583, EM8899
Transmission Mount
Part Number:
A6570 , EM8799
Denis
2025-08-21 17:34:09
Si me agradó mucho estoy muy satisfecho
John
2025-06-25 10:08:10
Put on a a friend's car he loves it! Says it doesn't shake anymore!
Braden Cornwell
2025-06-22 10:27:42
These are absolute trash! The front motor mount was ridiculous! You couldn’t get the locking-through-bolt through the damn mount! It was almost like the hole wasn’t drilled all the way through. I literally had to hammer the damn thing in!Then I decided to do the driver side mount. Was a mistake that was. Just as I got the damn thing in and I’m finishing the tightening; the lock nut/bolt on the damn mount CAME RIGHT OFF! It was secured by rubber. Whole a** threaded bolt came right out. And on this car that meant the motor wasn’t secured to the mount… like at all!Who the hell secures a threaded bolt with rubber?!?! These are disgusting. Get the mounts individually from autozone instead!I didn’t dare attempt to do the other two mounts! This company should be ashamed!
Betote
2025-05-20 10:47:30
Producto de calidad
Sammy19
2025-05-14 11:03:34
For perfect in my custom car.no modifying just unbolt and rebolt!
Yoni
2025-04-29 20:53:39
Hole are not correct. On one side two out of the three holes would line up or sometimes only one of three.
Jason Torres
2025-03-03 16:18:46
Not all bolt holes line up. Front mount fit just fine, both the left and right side mounts did not fit. Had to file open two holes that were about a 1/4 inch off. Did not install the rear mount, so not sure about this one.
PCTechGuy
2025-02-28 18:54:42
I'm a certified technician and these mounts are GARBAGE! They LOOK good but are terrible. I suspect the rubber dampeners are of very low quality. Once installed, the entire car vibrated A LOT more! I could hear everything rattling inside the car wow! Had to remove again. I have bought other A-Premium stuff before with good luck but these mounts are total garbage.
Andy
2025-02-16 13:52:01
I can't say anything bad about these aftermarket motor and transmission mounts. They saved my bacon when the front one let go When the car was full of passengers!I put these in a 2003 Hond Accord 6cyl 4door.The front one was easy to change, the side motor mount was even easier.The back one was a bit tricky but I got it out without removing the heat shield or the manifold.The one under the battery for some reason would just not line up so it actually took me just as long to install it as the first three. Go figure it's the smallest one!I have yet to install the transmission Stabilizer but I suspect it would be just as easy as the others.One word of caution. The rear motor mount mounting holes (The four holes at the bottom) did not line up correctly. Two holes barely lined up ( across from each other) but the others needed to be drilled out quite a bit. If I find Time I'll take a pic. I'm not sure what happened during manufacturing, but either it slipped in the welding jig, or they used the wrong base plate for a different application (Maybe the 4 cyl?) or the plate was welded upside down (or Backwards) because when i matched up the old one with the new one.....the holes lined up correctly.
Mauricio Amaro MejÃa
2024-12-06 18:16:24
Producto de buena calidad, el envÃo fue muy rápido
Ronald Santos
2024-12-04 14:51:16
Easy to install
Macjac
2024-12-01 18:34:57
The holes are not aligned properly specially the driver side, rear mount and passenger side, the only mount that fits is the front mount, don’t buy pls… listen to some comments
Recommended Products