Your cart is empty.
Your cart is empty. Overview: The 100W Series is available in both electronic header and in-line connection systems. This Micro-Pack Series connection is an excellent low energy system designed to meet the needs of high density applications, requiring protection from environmental hazards. APTIV 100W header connector mates to either flexible or hard circuit board applications.
Features & Benefits
Scott
2025-07-24 18:40:16
If you were looking for these to replace and repair your Dodge, Jeep, or Chrysler ECM connector pins, you found the right ones. Its WAY cheaper and simpler to get these vs an aftermarket pig tail kit. If you are working on your Jeep TJ, XJ, ZJ, or WJ- make sure you check the wiring underneath the tubing, and the Battery power distribution plate at your PDC fuse box for corrosion and damage. These two things will burn wires and blow your IOD fuse.
Ken
2025-07-18 16:58:56
Adding turn signals to my SXS. Bought these hoping they’d be the correct size for the instrument cluster for a 2024 Polaris RZR XP 1000. Wanted to see if I could figure out how to get the factory turn signal indicators in the cluster to illuminate when turn signals blink. Turns out this works perfectly. These are the exact same size and you need to wire the turn signals to pins 6 and 7 with these connectors. No one says that but this is the way!
DunerJim
2025-06-22 17:59:31
I had this somewhat crazy idea of adding directional signals to my RZR. I had planned to add two indicator lights to let me know they were on. Then I happened to glance at my dash in just the right light, and could see it had directional signal arrows built in. A quick look at a wiring diagram showed which two pins on the instrument panel connector were connected to the right and left indicators. I'm 70 years old, and my hands and eyes no longer do real well with detail work, but installing these pins in the connector was not terribly hard, and did not require any special tools. I ran wires from the newly installed pins to the left and right circuits I was installing. upon powering the system up, the dash indicators flashed right along with the turn signals. Note I did NOT have to add bulbs to the dash. The dash came with LED's or bulbs already in place.
Enrique S
2025-05-16 13:44:31
I was doing the Efan conversion on my 04 Silverado and needed to add two wires of the harness high speed and low speed. I looked around and no one made it clear if these fit a 3rd gen lm7 5.3 computer with the green and blue connectors on the ecu well they do! Don’t hesitate to buy these. The only issue I had was getting them to grab onto the wire and installing them in the right hole without bending but with time and patience it’ll work out!
Mario G.
2025-05-14 16:37:07
needed for my pick up
William K. Suit
2025-05-06 10:34:49
Arrived as promised , in good shape
A. Slack
2025-04-14 16:02:07
These worked perfect to fix the crappy aftermarket fan harness that I bought. Fit the PCM just fine
Rich
2025-01-01 21:22:17
Worked out perfectly for me adding a pin to my tahoe ecm for electric fan swap. Just make sure you crimp the top of the connector really good where it clamps onto the insulation of the wire. If you dont it wont go into the plug
Recommended Products
