Your cart is empty.
Your cart is empty.1 carburetor spacer stud kit 2.700 OAL
SHORTY
July 22, 2025
They are a perfect fit with a 1 inch carb spacer. Nice quality. I will definitely buy again..
michael artymowicz
June 14, 2025
Great product if you only have a 1" spacer. If you are using an above carb throttle bracket (1/4) they will be short on that side of the carb. Order longer ones for this instead ARP part # 2002408 may work better.
Brian S.
May 21, 2025
ARP fasteners aren’t cheap but the quality is worth it.
derek arterberry
January 28, 2025
Exactly like the description says
MTE
January 12, 2025
I bought a 1979 F-150 in November 2022 and I have been restoring it this summer. The old carb needed to be rebuilt after years of sitting but I ended up swapping to a new carb instead. Once we started getting air temps over 80* I noticed rough idle, hard to restart when warm and off-idle hesitation. The carb was too hot to touch when it started running like this. Did some internet sluething and due to low fuel pressures that carbs use and modern fuel blends, the fuel likes to vaporize at lower temps than it has in years past (or so the interwebs says) since most cars run modern fuel injection with much higher pressures these days this is a non-issue. So I need to keep temps down to keep the fuel from boiling in the carb...which brings me to these longer studs which I ordered with the Edelbrock 8725 carb spacer and Edelbrock 9266 heat insulating gasket. I needed studs that would be long enough for both the thicker gasket and spacer. I've not had the vapor lock issues since and the carb no longer gets too hot to touch, you can touch with bare hands as much as you want at full operating temp. No longer is it difficult to start when it is at operating temp. I love when it is something basic that you can do to fix the problem.
Christopher C.
December 27, 2024
these studs are high quality! fits my 350 with a one inch spacer and throttle bracket!!
Vance
November 22, 2024
Used these while using a 1" spacer with Holley carburetor.
Eleftheria Roberts
November 13, 2024
Liked
Recommended Products