Your cart is empty.
Your cart is empty.Product Description
Key Features
- Allows relocation of coil packs, one for each side
- Gives a greater flexibility to move the coils off from the valve covers.
- This is for a pair of 12-inch relocation connector wires.
Inclusion:
The package includes 2 x 12-inch LSX Coil Relocation Harnesses, one for each side.
Fitment:
Chevrolet Small Block V8 Gen. III/IV (LS Based)
- 4.8 L / 293 in3
- 5.3 L / 325 in3
Chevrolet Small Block V8 Gen. III/IV (LS Based)
- 5.7 L / 346 in3 commonly referred to as 350
- 6.0 L / 364 in3
Chevrolet Small Block V8 Gen. III/IV (LS Based)
- 6.2 L / 376 in3
- 7.0 L / 427 in3
Yousif buali
2025-09-06 18:44:57
Good quality
David
2025-07-10 14:30:24
No matter what way you route this the leads are too short and put too much strain and tension on the crimps. I had to extended and pretty much remake the whole harness.
Rolando velez casanova
2025-06-06 14:51:19
Good product and easy to install
Sami Lahti
2025-05-29 18:26:24
allgood
KINGxCRABB
2025-04-03 11:55:40
Â
Stein
2025-03-27 14:48:20
Great product got my project car up and running I had to undo the wire loom so I could get it to to each coil but I do have an ict coil holder on so it may be due to that
Jim Babbs
2025-03-07 15:01:55
fits good ,good quality
Brendan
2025-01-29 13:56:41
These are made with china knock off connectors, NOT Delphi quality.Splices for ground/power/low reference are just crimped and taped over with layer of electrical tape, I could see this being an issue after some time in service. I will remove terminal from white plug and slide some heavy wall heat shrink over the splice, and these should work fine.The cable seal on the large white plug does not seal the cavity, it is loose inside. The end at the coils does not even have the cable seals! nothing!
Recommended Products